OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL
Setting the manufacturer code (remote control signal assigned to each manufacturer) for your TV, VCR or DVD player on the remote control allows you to operate not only the
Note
•Depending on the model, certain components from other manufacturers cannot be controlled, or only limited functions can be controlled, even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the component.
2 Keeping CODE SET pressed, enter the 1- digit device code and the
You can release CODE SET after entering the code.
y
•The manufacturer code 99 has been set for the remote control selector buttons (TV, VCR and DVD/CD) at the factory.
3 Press POWER (TV or AV) and check that the component to be controlled turns on and off (standby).
Setting the manufacturer code
Manufacturer codes can be set for TV, VCR and DVD/CD buttons only.
Note
•TV manufacturer codes can be set for the TV button only. However, any of the manufacturer codes can be set for the VCR and DVD/CD buttons.
TV | POWER |
| POWER | AV | |
TV | AV | SLEEP |
|
| |
|
| TV MODE |
|
|
|
|
| INPUT |
| TUNER |
|
| CH |
| VOL |
| VCR |
|
| MUTE |
| VCR | |
| SUBTITLE |
| AUDIO |
|
|
| REC |
|
| VIDEO 2 |
|
|
|
|
| VIDEO 1 |
|
|
|
|
| CD | DVD/CD |
|
|
|
| DVD | |
CODE SET |
| CODE SET |
| AMP |
|
| HALL | JAZZ | ROCK | ENTERTAINMENT |
|
| 1 | 2 | 3 | 4 |
|
SPORTS | MONO MOVIE | MOVIE 1 | MOVIE 2 | Numeric buttons | |
5 | 6 |
| 7 | 8 |
|
/DTS | SELECT | MATRIX 6.1 | STEREO |
| |
9 | 0 |
| 10 | CANCEL |
|
TOP MENU | MENU |
|
| ||
LEVEL | SET MENU | MUTE |
| ||
| PRESET | ABCDE |
|
| |
CH | ENTER | CH |
|
| |
|
|
|
| ||
| PRESET |
|
|
| |
TEST | B.BOOST | VOL |
| ||
ON SCREEN | RETURN |
| |||
Precautions when performing the setting
You can operate the component using the TV, VCR or DVD player operation buttons on the remote control once the manufacturer code is set properly. If unsuccessful, perform the procedure from step 1 again. Pay attention to the following points when you perform the procedure.
•Check that the correct remote control selector button has been selected when setting the manufacturer code.
•If more than one code is given for a manufacturer, try entering each code in the order given.
•Remove and replace the remote control’s batteries (complete this step within 2 minutes) and then perform the procedure. While replacing the batteries, be sure not to press any button on the remote control. Doing so may erase the manufacturer code which has been set for other remote control selector buttons.
To reset the manufacturer code to the
Follow steps 1 to 2 for the procedure “Setting the manufacturer code”, and enter the device code for the component and “99” while pressing CODE SET in step 2. (It is not necessary to follow step 3.)
(U.S.A. model)
1 While pressing CODE SET, press the input selector button (TV, VCR, DVD/CD) for which the manufacturer code is to be set.
Only one manufacturer code can be set for each input selector button.
Note
•Keep pressing CODE SET between step 1 and 2.
•Refer to “LIST OF MANUFACTURER’S CODES” at the end of this manual.
32