Yamaha AVX-S80 owner manual Installing the speakers, Placing the center speaker, Cautions

SPEAKER SETUP

Installing the speakers

■Placing the center speaker

Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at two points on the bottom of the speaker and the top of the TV.

Fastener

Peel off the seal

Cautions

•Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may drop out causing an injury to you.

•Do not place the speaker on top of the TV with an inclination.

•Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.

•Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.

■Placing the front and rear speakers

When placing the front and rear speakers on a flat surface, attach the included non-skid pads to the corners on the bottom of the speakers as shown below. This prevents the speakers from sliding around.

Non-skid pad

■Mounting the front and rear speakers on a wall

When mounting the speakers on a wall, use the holes on the speakers’ back panels.

1 Fasten screws into a firm wall or wall support as shown in the figure.

			Tapping screw
			(Available at the
			hardware store)
				Diam. 3.5 to 4 mm
	Wall/wall	support
70 mm					70 mm

10 mm

Min.

20 mm

2 Hang the holes on the protruding screws.

Make sure that the screws are securely caught by the narrow parts of the holes.

70 mm

Warning

• Each speaker weighs 0.9 kg (11 lbs. 16 oz.). Do not mount them on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speakers may fall. This damages the speakers or causes personal injury.

• Do not install the speakers to a wall with nails, adhesives, or any other unstable hardware. Long-term use and vibrations may cause them to fall.

• To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall.

• Select a proper position on the wall to mount the speaker so that no one will injure his/her head or face.

10