On-Ceiling Mount Type Installation
1.Attaching Template and Installing STB-370PC
Attach the enclosed template to the ceiling, then drill a hole in the ceiling according to the diameter marked on the template. Drop the camera cables down from the ceiling through the hole. Next, install the Install Base
Before installing the exposed bracket, open the hinged door at the bottom of the bracket as shown in the picture. Hold the knob on the hinged door to open.
STB- |
|
370PC | Template |
|
Knob
2.Wiring Terminal Cables
Connect the cables to the terminal block on the hinged door. For the location of the wiring pins, please refer to the “Camera Wiring Diagram” on Page 12. Once the wiring is successful, close the hinged door.
Notes
• Do not connect the camera to a power outlet until the installation is complete. Supplying power in the middle of the installation may cause fire or damage the product.
On-Ceiling Mount Type Installation
3.Setting Up Camera DIP Switches
DIP switches for communication and ID protocols are located on the bottom of the camera. For the switch settings, refer to the appendix of this manual.
ID(SW1)
Protocol(SW2)
5.Connecting Camera Safety Cable and Attaching Camera
Carefully attach the camera to the mount following the alignment guide marks as shown in the picture. First hook the camera's safety cable on the mount, and then attach the camera. The safety cable is coiled inside the install base. As shown in the leftward picture, pull out the safety cable from the install base and then hook it to the mount.
| Alignment |
| Direction |
Safety | Guides |
Cable |
|
| Alignment |
| Direction |
| Guides |
Alignment
Directions
✽To attach the camera to the mount, refer to the alignment guide marks as shown in the picture.
Notes
• Make sure to first hook the camera's safety cable to the mount before proceeding. Otherwise you may be exposed to serious injury caused by a fallen camera.
22 SPEED DOME CAMERA ACCESSORIES | SPEED DOME CAMERA ACCESSORIES 23 |