Samsung SPD-3700T installation manual Attaching Camera

Page 15

Indoor Flush Mount Type Installation

7. Arranging Camera Cables and Closing Hinged Door Connect the cables to the terminal block on the hinged door.

For the location of the wiring pins, please refer to the “Camera Wiring Diagram” on Page 12.

Once the wiring is successful, close the hinged door.

Indoor Flush Mount Type Installation

Notes

• Make sure to first hook the camera's safety cable to the mount before proceeding. Otherwise you may be exposed to serious injury caused by a fallen camera.

8.Setting Up Camera DIP Switches

DIP switches for communication and ID protocols are located on the bottom of the camera. For the switch settings, refer to the appendix of this manual.

ID(SW1)

Protocol(SW2)

STH-

9. Attaching Camera

370PE

Carefully attach the camera to the mount following the alignment guide marks as shown

10. Assembling Dome Cover

Once the camera is successfully attached, secure the mount with the transparent dome cover.

Notes

• Be careful to not scratch the transparent cover during the assembly. Scratched dome covers may decrease the graphics quality and overall performance of the camera.

CLOSE OPEN

STH-370PE

in the picture. First hook the camera's safety cable on the mount, and then attach the

camera. The safety cable is coiled inside the install base. As shown in the leftward picture,

pull out the safety cable from the install base and then hook it to the mount.

 

Alignment

 

Direction

Safety

Guides

Cable

 

 

Alignment

 

Direction

 

Guides

 

Alignment

 

Directions

To attach the camera to the mount, refer to the alignment guide marks as shown in the picture.

To attach or detach the camera, refer to the picture.

*Attaching the camera: Hold up the camera and push it to the mount as shown in the picture. Push the camera until you hear a “click”.

*Detaching the camera: To detach the camera, pull the camera downward while pushing the unlock buttons on the camera upward.

Unlock Button

UNLOCK

To attach the

To detach the

camera

camera

28 SPEED DOME CAMERA ACCESSORIES

SPEED DOME CAMERA ACCESSORIES 29

Image 15
Contents Speed Dome Camera Accessories Installation Manual Table of Contents Product Category Product CategorySpeed Dome Camera Installation Category Speed Dome Camera Installation CategoryConnecting Housing and Bracket Pendant Type InstallationSecuring Wall Bracket and Wiring Preparing HousingAssembling Housing and Bracket Securing HousingWiring Terminal Cables Camera Wiring Diagram Connecting Camera Safety Cable and Attaching CameraPreparing Camera Assembling Dome Cover Dome Cover SettingAssembling STB-30PF and Pipe Preparing Pipe and Ceiling BracketSetting Up Camera DIP Switches Opening Hinged DoorAssembling Mount and Flange On-Ceiling Mount Type Installation On-Ceiling Mount Type InstallationAttaching Camera Attaching Template and Installing STB-370PC Indoor Flush Mount Type Installation Indoor Flush Mount Type InstallationAttaching Template Wiring and Arranging Anti-fall EyeboltsInserting the flush housing Attaching Flexible AdaptorAttaching Camera Mounting Accessory Installation Mounting Accessory InstallationCompatible Models STB-270PWV+STH-380PO/370PO/360PO/370PI STB-330PPM Paul MountSTB-340PCM Corner Mount STB-350PPM Parapet MountCeiling Exposed Mounting Indoor Flush Mounting Product External DimensionsWall Mounting Ceiling MountingModel Product SpecificationsMemo Sales Network