Sharp VL-AH130U operation manual Information

Page 3

WARNING—FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

CAUTION ON LITHIUM BATTERY (MEMORY BACKUP BATTERY)

If a battery is reversed (positive end where the negative end belongs and vice versa), it can overheat and rupture. This has happened when young children install batteries backwards. Warn children not to take out batteries or install them. Parents should install the lithium battery in the VIEWCAM.

Your VIEWCAM is designed to record in SP mode only. It will not perform normal playback for programs prerecorded in LP mode.

This VIEWCAM does not have a PCM recording or playback function. PCM recordings made using other VCRs or audio dubbing cannot be played back on this unit.

If you record on a tape on which PCM sound has already been recorded, the audio track of the new VIEWCAM recording may not come out if the tape is played back on a PCM-capable VCR. If this occurs, set the VCR’s audio monitor select switch to the “STANDARD” position.

COPYRIGHT WARNING: It is the intent of SHARP that this unit be used in full compliance with the copyright laws of the United States and that prior permission be obtained from copyright owners whenever necessary.

NOTE

The VIEWCAM’s LCD panel is a very high technology product with close to 90,000 thin-film transistors*, giving you fine picture detail. Occasionally, a pixel may appear on the screen as a fixed point of blue, green, red, or black. Please note that this does not affect your VIEWCAM’s performance.

*Specifications are subject to change without notice.

ii

Page 2 Page 4
Image 3
Page 2 Page 4
Contents VL-AH130U See page 54 for use of Demo modeApplies to the supplied AC adapter Thank you for purchasing this Viewcam from SharpInformation Should never be blocked by placing IiiPage Avoid shocks and dropping Do not aim the lens at the sunLCD Monitor Screen Recording FormatVii Tripod adapter For 180 recording ViiiContents Gamma Brightness Compensation Useful FeaturesAdvanced Features ReferencesCassette compartment door p When the cassette compartment door is openPart Names Operation SummaryRemote sensor p Rear viewQuick Reference Index Video cassette is defective and should be Inserting and Removing Battery PackInserting the Battery Pack Removing the Battery PackCharging the Battery Pack ContinuousTime Powering the Viewcam from an AC Outlet Perform above, then take out the cassette Inserting and Removing a CassetteInserting a Cassette Removing a CassetteRemoving the Lithium Battery Installing the Lithium Memory BatterySetting the Language Selecting the Language for the On-screen DisplayChanging the Language VCR Mode Camera ModeFrench On-screen Displays Spanish On-screen Displays 0 0 Setting the Date and TimeChanging to the 24-hour Time Mode Press the SET button BLCD screen side Using the Hand Strap and the Lens CapAttaching the Shoulder Strap Attaching and Removing the Lens CapMaximum Continuous Recording and Actual Recording Times Easy Camera Recording with Full Auto ModeTo Turn the Power Off To Pause RecordingZooming Tips on Recording PositionsBasic Operations Camera Recording Remaining Battery Power Display Approx. remaining On-screen Recording time IndicatorRemaining Recording Time Display Auto Tape Rewind Volume ControlPlayback To Stop PlaybackWatching the Playback on a This Viewcam does not have an S-video socketPlayback Basic Operations Playback Video SearchStill SlowDisplay button Useful FeaturesOperations of the On-screen Controls Menu buttonPress Button C or D toSelect the desired menu item Recording the Date and Time Type of Fade Modes Selecting Fade ModeUsing Fade Mode Fade In and Fade OutTo cancel Fade mode Quick ReviewTo use fade out only QU I CK Quick Return Edit SearchPress the Gama EFF. button a again To cancel Gamma Brightness CompensationGamma Brightness Compensation To obtain a brighter pictureGain-up Cat’s Eye To cancel the gain-up functionTo return to normal picture Wide ScreenMacro Shots Removing the Lens HoodTo pause recording, press the REC Stop button B Self RecordingNormal Self Recording More Information on Self RecordingSelf-recording Message Blue Setting the Viewcam to Full Auto ModeFeatures Program SearchUseful To turn off the tape counter Tape Counter FeatureUsing the Counter To reset the counter to zeroUsing the Counter Memory During playback, press the Menu Button until appearsPress the Play button D to view the desired scene Operating the Remote Control Using the Remote ControlInstalling the Batteries in the Remote Control Turning On the Remote Control ModeType of Digital Picture Effects To cancel the digital picture effectAdvanced Features Digital Picture EffectsSelect Scene Menu in above Type of Scene SettingsTo cancel the scene setting Scene Menu Program AESuperimposing a Title Top of the screen and the cursor will Changing the Preset TitlesPress the Reset button to display the title input screen Press the or ß button Q to selectManual Focus To cancel Manual Focus modeAuto/Manual Focus Auto FocusTo cancel White Balance Lock White Balance LockPress the White BAL. button. White BAL. returns to blue To cancel Manual Exposure mode Manual ExposurePerform steps 1 and 2 above, then press the Auto button B Picture/Backlight Adjustments Press the Menu button until Camera mode or VCR mode appearsType of Backlight Modes Press the Gama EFF. button again. Gamma disappears To cancel Gamma PlaybackGamma Playback Turning Off the LCD Monitor BacklightTo stop editing Setting Edit ModeEditing Cutting Unwanted SequencesTips on Good Lighting Useful InformationHints for Better Shooting LightingDirty Video Heads Dew FormationReplacing the Fluorescent Lamp Battery PackAC Adapter CleaningUsing Your Viewcam Abroad References Video Cassette TapesDemonstration Mode Canceling Demo ModeWatching the Demonstration Symptom Possible cause Suggested solution Before Requesting ServiceVCR AC Adapter UADP-0312TAZZ SpecificationsService Information For the U.S Battery Pack BT-H22Extracció n de la batería Inserció n y extracció n de laBatería Inserció n de la bateríaCarga de la batería Selecció n de idioma para la visualizació n en pantallaGuía de operació n rá pida en españ ol Realice el paso 1 de arriba y luego saque el videocasete Inserció n y extracció n de un videocaseteInserció n de un videocasete Extracció n de un videocaseteBatería Para hacer una pausa en la grabació nPara desconectar la alimentació n Pulse el botón REC START/STOP para iniciar la grabaciónRebobinado automá tico de la cinta Control de volumenReproducció n Para detener la reproducció nOsaka, Japan Valid for warranty service in the U.S. onlyWhere to Obtain Service What to do to Obtain Service Sharp Plaza, Mahwah, New Jersey
Top Page Image Contents