●Configuring the HTTP port number
1)Enter the HTTP port number in “HTTP Port Number” (default: 80).
•For most applications, select 80 (default: 80).
2)Click the “Change” button.
●DNS update to DNS 1/2 Server
When you set a domain name (FQDN) for the camera, you can access the camera with the domain name.
1)To set a domain name, check "Enable". (Default: Disable)
2)Enter both the host name and domain name.
3)Click the "Set" button.
●Framerate Control
By setting framerate appropriate for the environment where the camera is installed or the purpose, you can control the number of images to be sent from the camera. (Unit: FPS)
1)Select the framerate from the
2)Check "limited to". (Default: unlimited)
*The settings above have an effect on all the communication (bandwidth) of the camera.
*If the current resolution is VGA, 22 fps is the highest framerate. (As for QVGA or QQVGA, 30 fps)
*The framerate you set may not be obtained depending on the networking conditions.
Important
●If you do not know the subnet mask, consult the provider or relevant network system administration support center.
●You do not need to enter the default gateway if the network camera will not be accessed from another network. If you do need to enter a default gateway, consult your network system administration support center.
●When you try to reconnect to the network camera, be sure to confirm that the entered IP address and HTTP port number are new ones if you changed the IP address and HTTP port number.
Installation/Set up and OperationViewing
Recording
Setting up
Others
67