IBM 8090, 8088, 8086, 8089, 8087 manual User Guide

Page 32

2.Pivot the drive bay assembly upward to gain access to the hard disk drive.

3.Disconnect the signal and power cables from the rear of the hard disk drive.

4.Lift the hard disk drive and bracket up to remove it from the drive bay.

5.Note the orientation of the hard disk drive in the plastic bracket.

6.Remove the drive by flexing the plastic enough to slide the drive out.

7.Install the hard disk drive into the plastic bracket by flexing the plastic enough to slide the drive in.

8.Install the hard disk drive and bracket into the bay until it snaps into position.

9.If you are replacing a parallel ATA hard disk drive, place the master/slave jumper on the drive in the same position as on the drive being replaced. Also refer to any instructions that come with the drive.

18User Guide

Image 32

Contents User Guide Types 8086, 8087 Types 8089 Page User Guide Types 8086, 8087 Types 8089 Page Contents Iv User Guide Important safety information Conditions that require immediate actionPower cords and power adapters General safety guidelinesService Batteries Extension cords and related devicesPlugs and outlets CD and DVD drive safety Heat and product ventilationAdditional safety information Lithium battery noticeModem safety information To connect To disconnectPower supply statement Laser compliance statementOverview Information resourcesXii User Guide Installing options FeaturesVideo subsystem Operating systems preinstalled varies by model type Specifications Supported operating positions Available optionsHandling static-sensitive devices Installing external options Locating the connectors on the front of your computerLocating the connectors on the rear of your computer Connector Description Obtaining device driversOpening the cover Locating components Identifying parts on the system boardInstalling memory Installing options Installing a PCI adapter What to do nextWhat to do next Installing internal drives Removing and replacing an optical driveRemoving and replacing a hard disk drive User Guide Connecting a parallel ATA hard disk drive Security features Integrated cable lock Password protectionChanging the battery Erasing a lost or forgotten password clearing Cmos Closing the cover and connecting the cables User Guide Using the IBM Setup Utility program Starting the IBM Setup Utility programViewing and changing settings Exiting from the IBM Setup Utility programUser password Administrator passwordSetting, changing, and deleting a password Using Security Profile by DeviceUsing IDE Drives Setup Selecting a startup deviceSelecting a temporary startup device Changing the startup sequenceUser Guide Updating flashing Bios from a diskette Updating flashing Bios from your operating systemAppendix A. Updating system programs System programsRecovering from a POST/BIOS update failure Appendix A. Updating system programs User Guide Cleaning a mouse with a ball Appendix B. Cleaning the mouseCleaning an optical mouse User Guide Appendix C. Manual modem commands Basic AT commandsLow speaker volume Set Pulse dial as defaultSet Tone Dial as default Internal speaker on until carrier detectedExtended AT commands MNP/V.42/V.42bis/V.44 commands Fax Class 1 commands Fax Class 2 commandsVoice commands Appendix C. Manual modem commands User Guide Tier 2 CRUs Appendix D. Customer replaceable unit CRU parts listTier 1 CRUs User Guide Appendix E. Notices Television output notice TrademarksIndex Security integrated cable lock Page Part Number 19R2375