Toshiba CS3950D Switching via rear-panel DIP SW, Initial factory setting Rising edge, 2SC3734

[Shutter trigger spec]		Exposure-starting-cue signal in random trigger shutter mode
(1)	Input level	LOW level: From 0 through 0.5V
		HIGH level: From 4 through 5V
(2)	Input impedance	High impedance (10k-ohm)
(3)	Capture timing	Rising edge detection (Positive) / Falling edge detection (Negative)
		(Switching via rear-panel DIP SW)
		(Initial factory setting: Rising edge)
(4)	Pulse width	Minimum 2 micro s
		Maximum 1/8s
[Sync signal spec]
(1)	Readout signal	WEN readout timing pulse
(2)	Polarity	Negative
(3)	Pulse width	1H output
(4) Output circuit
		5
		2SC3734	V

WEN

100

2SA1461

WEN OUT

50

[Electronic shutter spec]

(1)Normal shutter Shutter-speed setting via rear-panel SW (Initial: OFF)

12 steps switch-able (= OFF, 1/60s, 1/125s, 1/250s, 1/500s, 1/1000s, 1/2000s, 1/5000s,1/10000,1/20000,1/50000,1/100000)

(2)RTS (a)Operation mode

No.	Reset	Exposure	Sync
1			Internal
		Rear SW
2			Consecutive HD / Consecutive VD IN
		(FIX mode)
3	Non-reset		Consecutive HD / Single VD IN
4			Internal
		TRIG pulse width
5			Consecutive HD / Consecutive VD IN
		(PULSE width mode)
6			Consecutive HD / Single VD IN
7		Rear SW	Internal
8	V-reset	(FIX mode)	Consecutive HD IN
9		TRIG pulse width	Internal
		(PULSE width mode)
10			Consecutive HD IN

Notes : * RTS mode automatically switches over through TRIG IN **RTS disabled under Electronic shutter OFF

(b)Multiple shutter	Multiple shutter via ext. trigger signal and ext. VD signal
	Notes : * Operation like No.3, 6 above

8

D4133738B