Toshiba CS3950D Switch setting CCU rear-panel DIP SW, Set No.9 OFF when Trig in Open

[Switch setting]

(1) CCU rear-panel DIP SW

No.	Function	OFF	ON
1
2	E-shutter-speed	See shutter-speed table (Table 1)
3	(SHUT)
4
5	Shutter mode	See shutter-mode table (Table 3)
6	(SMODE)
7	Partial scan	See partial-scan table (Table 2)
8	(PART)
9	TRIG polarity	Positive	Negative
		(Rising edge)	(Falling edge)

Notes: *Initial factory setting: All OFF

**Set No.9 OFF when TRIG IN OPEN.

1

SHUT 23 4

5 SMODE 6

7 PART 8

O N

(Table 1) Electronic shutter-speed

Shutter-speed	No.1	No.2	No.3	No.4
OFF	OFF	OFF	OFF	OFF
1/60s	ON	OFF	OFF	OFF
1/125s	OFF	ON	OFF	OFF
1/250s	ON	ON	OFF	OFF
1/500s	OFF	OFF	ON	OFF
1/1,000s	ON	OFF	ON	OFF
1/2,000s	OFF	ON	ON	OFF
1/5,000s	ON	ON	ON	OFF
1/10,000s	OFF	OFF	OFF	ON
1/20,000s	ON	OFF	OFF	ON
1/50,000s	OFF	ON	OFF	ON
1/100,000s	ON	ON	OFF	ON
Not acceptable	OFF	OFF	ON	ON
Not acceptable	ON	OFF	ON	ON
1/100s(FL)	OFF	ON	ON	ON
Pulse width	ON	ON	ON	ON

(Table 2) Partial-scan

Partial scan	No.7	No.8
OFF	OFF	OFF
1/2 partial	ON	OFF
1/4 partial	OFF	ON
Not acceptable	ON	ON

TRIG 9 0

Notes : *Don’t set Electronic shutter-speed in OFF under RTS mode.

(Table 3) Shutter-mode

	Shutter mode		No.5	No.6	SYNC
Random		V reset	OFF	OFF
		Not acceptable	ON	OFF	Internal sync
trigger
		Non-reset	OFF	ON
Not acceptable			ON	ON
		Non-reset	OFF	OFF	Single VD
Random		(Multiple shutter)
						Ext. sync
trigger		Non-reset	ON	OFF	Consecutive VD
						HD IN
		V reset	OFF	ON	No VD
	Restart / Reset		ON	ON	Single VD

Notes : * Under normal shutter mode partial-scan, set No.5, 6 in OFF. **Under PULSE W mode, SYNC reset is disabled.

(2)CCU rear-panel SW

Function	SW	Selected Function
Ext. SYNC IN impedance	HIGH	HIGH impedance (Initial factory setting)
(HD/VD)
	75Ω	75Ω
GAIN selection (GAIN)	F	Factory-set GAIN
	M	Manual GAIN adjustable via GAIN potentiometer

12

D4133738B