Toshiba CS3950D specifications Connector pin assignment Compatible connector, Pin assignment

Page 17

[Connector pin assignment]
(1) Compatible connector				HR10A-10P-12S (Supplied by HIROSE ELEC.)
(2) Pin assignment

	Pin	Signal
	No.	(Standard)		Connector pin layout
	1	DC12V GND
	2	DC12V		①	⑨

	3	VIDEO GND
	3	VIDEO GND
	4	VIDEO OUT		②	⑩	⑧
	5	HD GND		③ ⑪	⑫	⑦
	6	HD IN		③ ⑪	⑫	⑦
	6	HD IN

	7	VD IN		④	⑥
	8	TRIG GND			⑤
	9	NC

	10	WEN OUT		12 pin male		Picture Rear-panel camera connector
	11	TRIG IN				(Rear-view)

	12	VD GND

Notes : *Before connecting / disconnecting the connector, make sure the camera power is OFF. **For board connection, check compatibility.

11

D4133738B

Image 17

Contents CCD Camera CS3950D Specification Before USE General Safety Instructions This device for repair service Device for repair service/technical adviceDo not supply any power other than specified Do not disassemble this devicePurchased this device for repair service Do not damage the power cordUnplug the power-plug when the your device is not in use Do not attempt to make connection before turning power offRestriction for USE Discramer Rimited WarrantyAvoid irregular signal interface Other Instructions Product Description FeaturesConfiguration Nega Operation ModeOption Unit Trig CCD Supply consecutive HDUnder other shutter modes 35H 137H 21H Input level From 2 through 4V p-p Input impedance SpecificationsInitial factory setting High Initial factory setting Rising edge Switching via rear-panel DIP SW2SC3734 100 2SA1461Shutter Normal Weight Approximately 130g Lens mount Mount GND / insulation Mechanical spec External dimensionTemperature From 0 through 40 C Operation guaranteed Temperature From -5 through 50 CPin assignment Connector pin assignment Compatible connectorSet No.9 OFF when Trig in Open Switch setting CCU rear-panel DIP SWOptical black characteristics 1H rate timing Timing ChartRate timing Ext. VD Ext. HD phase differenceEXTERNAL-VIEW Drawing Design and specification is subject to change without notice