Toshiba CS3950D specifications Option Unit, Operation Mode, Nega

Page 8

4.OPTION UNIT

(1)DC SYNC IN cable ············Model name : CPRC3700 [2m,3m,5m,10m]

(2)Camera adapter ···················Model name : CA170

(3)Camera-mounting kit············Model name : CPT

*Contact your dealer / distributor for details of option units. *Conformity of an option part and EMC conditions

About the conformity of EMC standard of this machine, it has guaranteed in the conditions combined with the above-mentioned option part.

When used combined parts other than specification of our company, I ask you to have final EMC conformity checked of a visitor with a machine and the whole equipment.

5.OPERATION MODE

(1)GAIN selection (Camera rear-panel SW) Switches sensitivity setting

(1-1) FIX -------------------Factory-prefixed gain

(1-2) MANU ---------------Gain is adjustable via the manual gain potentiometer (M.GAIN)

(2)TRIG selection (Camera rear-panel DIP SW)

Switches TRIG input signal polarity used under RTS mode

(2-1)

POSI------------------

Positive polarity (rising edge detection)

(2-2)

NEGA----------------

Negative polarity (falling edge detection)

(3)RTS (Random Trigger Shutter) exposure selection (Camera rear-panel DIP SW) Switches light exposure mode under RTS mode

(3-1) FIX mode------------ Rear DIP SW

Exposure-time control via rear-panel DIP switch

(3-2) PULSE W mode----TRIG signal pulse width control

Exposure-time control via TRIG signal pulse width

(4) Shutter mode selection (Camera rear-panel DIP SW or TRIG signal IN [Automatic]) Switches shutter mode

(4-1) NOR mode ----------Normal electronic shutter

Exposure control via internal sync signal

High-speed shutter: From 1/100,000s through OFF (12 position) (4-2) RTS mode -----------Random trigger shutter

Exposure control via ext. trigger or ext. sync input Timing charts are shown below. (TRIG timing: Positive) Notes: * RTS selection is automatic with TRIG status

**Neither under FIX nor PULSE W mode, RTS doesn’t work if Electronic shutter speed SW is set in OFF position.

2

D4133738B

Image 8
Contents CCD Camera CS3950D Specification Before USE General Safety Instructions Device for repair service/technical advice This device for repair serviceDo not supply any power other than specified Do not disassemble this deviceDo not damage the power cord Purchased this device for repair serviceUnplug the power-plug when the your device is not in use Do not attempt to make connection before turning power offRestriction for USE Discramer Rimited WarrantyAvoid irregular signal interface Other Instructions Product Description FeaturesConfiguration Nega Operation ModeOption Unit Trig Supply consecutive HD CCDUnder other shutter modes 35H 137H 21H Input level From 2 through 4V p-p Input impedance SpecificationsInitial factory setting High Switching via rear-panel DIP SW Initial factory setting Rising edge2SC3734 100 2SA1461Shutter Normal Mechanical spec External dimension Weight Approximately 130g Lens mount Mount GND / insulationTemperature From 0 through 40 C Operation guaranteed Temperature From -5 through 50 CConnector pin assignment Compatible connector Pin assignmentSwitch setting CCU rear-panel DIP SW Set No.9 OFF when Trig in OpenOptical black characteristics Timing Chart 1H rate timingExt. VD Ext. HD phase difference Rate timingEXTERNAL-VIEW Drawing Design and specification is subject to change without notice