Toshiba IK-DF02A instruction manual

Page 3

¥ The CAUTION label, shown on the left, is attached on the camera.

CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated Òdangerous voltageÓ within the productÕs enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING :

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION :

CONNECT 24V AC UL LISTED CLASS 2 POWER SUPPLY.

FIELD INSTALLATION MARKING : WORDED: "THIS INSTALLATION SHOULD BE MADE BY A QUALIFIED SERVICE PERSON AND SHOULD CONFORM TO ALL LOCAL CODES."

FCC (USA)-INFORMATION

NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

USER-INSTALLER CAUTION : Your authority to operate this FCC verified equipment could be voided if you make changes or modifications not expressly approved by the party.

- 2 -

Image 3 Contents
Dome Camera Table of ContentsImportant Safeguards Page Disclaimer Components Features and DescriptionPan ADJ Screw Part Names and FunctionsConnections Basic connection single system configurationLine lock Control OFFInstallation Installing the CameraCover Removal with the Tamper Resistant Feature Enabled To Determine Which Set of Mounting Holes to Use Mounting HolesInstallation to a Wall or Ceiling Ii Notching Out a Hole for the Wires Mounting Screw x Not supplied Ii Mounting the Camera to a Switch Box Positioned Sideways Ceiling Adjusting the Viewing Angle Backlight Compensation BLC Line Lock PhaseDo not shoot intense light Keep the camera installation away from video noiseCheck the ambient temperature and humidity Do not aim the camera at the sunCondition Check Points Case of ProblemsOn / OFF DIP-SW SpecificationsExterior View Wall Memo Limited Warranty
Related manuals
Manual 24 pages 63.15 Kb Manual 2 pages 60.41 Kb