3. PART NAMES AND FUNCTIONS
Pan ADJ Screw
Turn the
Horizontal ADJ Ring
Turn the ring to adjust the horizontal angle of image.
Lens Iris ADJ
Use to compensate for the iris level.
Turn toward L (low) for a darker picture.
Turn toward H (high) for a brighter picture. Optimum value is adjusted at the default setting.
V Phase ADJ
Adjust the phase difference between this camera and other cameras in Line Lock mode.
Power Input
Wire
Connect the power cable to 24V AC or 12V DC.
Length: approx.
12 inches (300mm)
Video Wire (BNC Tap)
Connect the video cable to a monitor or video device.
The image is outputted when powered on.
Length: approx. 12 inches (300mm)
Mode Setting Switch
1 2 3 4
ON
OFF
1:BLC (Backlight Compensation Control) When switched on, it automatically adjusts to compensate for subjects that are lit from behind.
2:AGC (Auto Gain Control)
When switched on, it automatically adjusts the image in relation to the brightness of the subject.
3:DC/AES
Not available for this camera. Be sure to switch to ON.
4:LL (Line Lock)
When switched on, its function is activated. Line Lock is available with 24V AC only.
Tilt ADJ Screws
Turn the screws to adjust the lens tilt angle. Fasten and lock them after completing the adjustment.
MON (Monitor Out)
When installing the camera, it is available to check the image with monitor out harness wire.
- 5 -