Switched to the appropriate mode for

Operating Your Camera

DAY&NIGHT (ICR TYPE) : Select from COLOR, BW, AUTO or EXT modes. •AUTO: According to the input luminance level, IR Cut Filter is automatically

switched to the appropriate mode for

daytime or night-time. The COLOR mode is operated for daytime, and it converts to BW mode for night-time

•COLOR : COLOR mode

•B/W : BW mode. Please press SETUP button to turn on or off the burst signal on BW mode.

•EXT: It enables user to control DAYNIGHT mode by external input signal. (refer to p20)

Note

•If AGC is OFF, you can't select AUTO mode.

When selecting the BW mode, ‘AGC’ function is fixed to HIGH mode.

When DayNight mode is set to Auto under the condition which the strong IR light is flickering periodically, a malfunction of IR-Cut filter may occur.

DZOOM : Configure Zoom magnification rate from

X2~X10 using this feature.

•Please press the SETUP button.

•Please select the ZOOM RATE from X2~X10.

SYNC : Two SYNCHRONIZATION modes are available INTERNAL and EXTERNAL LINE- LOCK. In LINE-LOCK mode, it synchronizes the video signal between cameras without a synchronous generator. The line-lock synchronization is only used in the areas of 60Hz (NTSC Models) / 50Hz (PAL Models).

COLOR CCD CAMERA

34 User’s Manual

- INT : Internal synchronization

- LL : External line-lock synchronization

•If you choose ‘LL’, you can adjust the desired phase. Press the SET button.

•You can adjust the desired phase from 0 to 359.

Note

•When the power frequency is 50Hz, you can not use line-lock mode (NTSC Models).

•When the power frequency is 60Hz, you can not use the line-lock mode (PAL Models).

•‘Sync.’ mode is fixed to ‘INT’ in DC 12V input power.

MOTION DETECTION : Your camera transmits an alert signal when it detects motion of an object on the screen. If you connect the camera to an external alarm. you can pay attention to the screen when the alarm sound. This feature is useful when you have to monitor several screens simultaneously.

•Please press the SETUP button.

-OFF : MOTION DETECTION mode is cancelled.

- ON : Any motion in the selected areas is observed.

• Please select the area you wish to observe from the 3 areas in AREA SEL mode.

• Please select ON mode for the chosen area.

•Please adjust the size of the area to be observed by using the UP, DOWN, LEFT or RIGHT button.

•Please press the SETUP button to save the changes and complete the setting.

Note

• Connect an external alarm device to MD Out on back of the camera. (refer to P20 )

COLOR CCD CAMERA 35 User’s Manual