To reset your camera to factory default condition

Operating Your Camera

Notes

•For NTSC models, the line-lock mode can be used if the external SYNC signal frequency is at 60Hz.

•For PAL models, the line-lock mode can be used if the external SYNC signal frequency is at 50Hz.

COMM ADJ: Use this feature to select communication protocol (refer to p.46~ p.51 for details). Position the indicator over 'COMMUNICATION' using the UP or DOWN button.

•CAM ID : Assign an ID number to the camera (1 to 255).

Identification number zero is used for Remote controller setup. •DISP CAM ID: Displays camera ID on top left corner of the screen.

•BAUD RATE : Configure baud rate from 2400/4800/9600/19200/38400/57600 bps.

•UART MODE : Configure parity bit to NON, EVEN, or ODD. Data bit is set to 8bit, and stop bit to 1bit. Set the UART MODE to EVEN if using the Remote Controller.

•RET PKT : Used to transfer a packet.

•END

IMAGE ADJ: Includes image quality or special function factors.

COLOR CCD CAMERA 40 User’s Manual

•FREEZE: Use this feature to freeze capture an image.

•H-REV: Use this feature to horizontally inverse the screen.

•V-REV: Use this feature to vertically inverse the screen.

•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting, however, produces noise and may obscure the image.

•COLOR : Adjusting this value affects the chroma level only; the burst level is unaffected.

END: evert back to the USER PRESET menu.

RESET

To reset your camera to factory default condition.

EXIT

To finish setup menu.

COLOR CCD CAMERA 41 User’s Manual