Samsung SDZ-300 instruction manual Connection, Connecting to Monitor, Connecting to Power

Page 8

Overview

Power Input Terminal

Power supply terminal (DC12V±10%).

Power LED

Illuminates when power is supplied.

Video Output Jack

Used to connect an external video monitor in jack.

Communication Control Connector

Used to connect the Remote Controller (Optional). Includes external 'SYNC' signal input pin, which is used for the line lock function.

Includes the RS-485 communication pin.

External Control Connector

Relates to the motion detection output signal.

Zoom and focus functions can be controlled using external siganals.

Connection

Connecting to Monitor

Connect Video Out Jack to the monitor's Video In jack as shown below.

CCD Camera

Monitor

•Connection methods may vary depending on the video equipment. Please refer to the model specific instruction manual.

•Connect cables with the unit powered down.

COLOR CCD CAMERA 14 User’s Manual

• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate device.

CCD Camera

Intermediate

End monitor

Connecting to Power

Each model has a different power input specification.

Please check the model type and standard power requirement before connecting to power.

DC Power Type (DC 12V, 500mA)

Use DC 12V/500mA power source for SDZ-300ND/PD.

Power Input Terminal

AC/DC Power Type

Use AC24V/500mA or DC 12V/500mA power source for SDZ-300N/P.

Notes

•Connect the power once the installation is complete.

•The wire is polarized. Match '+' and '-' terminals properly.

COLOR CCD CAMERA 15 User’s Manual

Image 8

Contents About this manual Sales NetworkCorrect Disposal of This Product Features Contents Precautions Do not install in high humidity environmentOverview TopTripod Mounting Bracket Screw Hole Used to fix tripod mounting bracket on top of the cameraBottom Back Key ButtonsTripod Mounting Hole To see a far object clearlyConnection Connecting to MonitorConnecting to Power Connecting to connection FunctionZoom FocusMenu Configuration Menu SetupOperating Your Camera Use the six buttons on back of the cameraCam Title Correcting MistakesWhen completed, move the cursor to END and press SET button Set White BAL using the Left or Right buttonWhite Balance Control Three white balance control modes are as followsTips on Using the Motion Detection Feature BacklightMotion Detection On Any motion in the selected areas is observedONE Push Focus is automatically adjusted just once Can be manually adjusted, independent of moving zoomPress the SET button Moving zoomEND To revert to the main setup menu Fast To move zoom fastAuto The iris is automatically activated upon illumination Shutter Control image brightness by adjusting shutter speedPress the SET button to confirm High MiddleLOW OFFOFF Disabled User PresetPreset Clear Clear configured preset END Revert to the Special Setup menuArea SEL TOPBottom LeftTo reset your camera to factory default condition To finish setup menuCAM ID Assign an ID number to the camera 1 to RET PKT Used to transfer a packetTroubleshooting Specifications SDZ-300PDReset Focus FarFocus Near Zoom WideOSD Menu On/Off OSD Menu Up OSD Menu DownOSD Menu Left OSD Menu Right89 / 336 / EEC Manufacturers Name Manufacturers Address Signature Full NamePosition PlaceMemo