Samson UHF 801 owner manual Guided Tour UR1 Rear Panel

Guided Tour - UR1 Rear Panel

1

2

3

4

ENGLISH

AC CABLE LOCK

DC INPUT	UNBALANCED
	OUTPUT

+ -

CAUTION:

USE SAMSON

AC ADAPTOR -10dB 5KΩ

ONLY

CABLE LOCK: LOOP THRU AND TIE

BALANCED SWITCH	BALANCED OUTPUT
LINE:
-20dBm600Ω
MIC:
-40dBm600Ω	XLR:
MIC LINE
	1 GND
	2 HOT
POWER RATING	3 COLD
DC 12V, 1.9W(160mA)

1:DC input - Connect the supplied 12 volt 160 mA power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter; doing so can cause severe damage to the UR1 and will void your warranty.

-

Using the strain relief: Gather up a loop of wire and pass it through the strain relief, then pass the adapter plug through the loop in order to create a knot.

2:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the UR1 to consumer (-10) audio equipment. Wiring is as follows: tip hot, sleeve ground.

3:Audio Output Level switch - Sets the audio output level attenuation of the balanced output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the “Setting Up and Using the Series One System” section on page 8 in this manual for more information.

4:Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the UR1 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).

*If required, both the unbalanced and balanced outputs can be used simultaneously.

UHF Series One Frequency Conversion Chart

Channel	Frequency
U1	801.375 MHz
U2	801.875 MHz
U3	803.125 MHz
U4	803.750 MHz
U5	804.500 MHz
U6	804.750 MHz

6