WIRELESS/REMOTE FLASH MODE
Taking Photos
1.Set up a camera with a controller, and
•See page 43 for details.
•When using the 5600HS (D) as the controller and a flash other than the D flash (see page 6) as the
2.Check that both flash units are fully charged.
•The AF illuminator on the front blinks, and 
on the rear is lit, when the 5600HS (D) is fully charged.
3.Use test flash to check the off-camera flash.
•The method used for test flash differs with the camera used (eg. press the AE lock button, or spot AE lock button). See the camera manual for details.
•If the test flash doesn’t fire, change the position of the camera, flash, and subject, or point the wireless/remote
4.Check again that both flash units are fully charged, and press the
The controller and
intensity of 1 and 2 respectively. See photo 
on page 40.
•
.
Setting Up The Controller
(The following applies when the 5600HS (D) is used as the con- troller.)
1.Set up the 5600HS (D) with the wire- less controller as described in 1~4 on page 48.
2. Press the select button to blink [RATIO].
3. | Press the + or – button to select | FLASH | |
| |||
| . | WIRELESS | |
4. | Press the select button. | ||
| |||
5. | Attach the 5600HS (D) to the camera. |
| |
|
|
|
Setting Up The Off-Camera Flash
Set up the 
cannot be used.
Taking Photos
The same method is used as for photography without
•Set shutter speed to 1/60 of a second or less (low shutter speed). Wireless
50 | 51 |