Minolta 5600HS (D) appendix Press the select button Using with 3600HS D or

WIRELESS/REMOTE FLASH MODE

2. Press the select button to blink [RATIO].

3. Press the + or – button to select

for one flash, and for another.

• The flash set to provides 1/3 of the

whole light intensity. flash provides 2/3 of the whole intensity.

•Do not set both flashes to the same ratio. Proper exposure may not be obtained.

4. Press the select button.

Using with 3600HS (D) or 3500xi

Set up the 5600HS (D) with the wireless ratio off-camera flash in the

same way as described in 1~4 on page 53~54, and select . Set up the 3600HS (D) or 3500xi with the wireless off-camera flash. (See flash or Wireless Remote Flash Controller manual for details.)

Ratio is set to automatically, and provides 2/3 of the whole light intensity.

Taking Photos

Refer to the Wireless Remote Flash Controller manual.

• Set shutter speed to 1/30 of a second or less (low shutter speed).

CONNECTING CAMERA AND FLASH BY CABLE

The use of the optional off-camera cables allows photography with the flash units separated from the camera. Up to four flash units can be connect- ed. The ability to take photographs without the need to consider position- ing of the flash units provides for con- siderable freedom to create a variety of shadow effects on the subject.

	• Flash units with accessory terminals	CABLE
	can be connected directly. When con-
	necting the 5600HS (D), remove the
	terminal cap and plug the cable into
	the accessory terminal.	BY
Flash Units		CONNECTING

Use the following flash units for off-camera flash photography by cable.

A group: 5600HS (D), 5400HS, 5400xi, 5200i

B group: 3600HS (D), 3500xi, 2000xi, 3200i, 2000i

•In this mode, ADI metering and pre-flash metering will be canceled and TTL flash metering will be used automatically.

Continued on next page

54 55