Sanyo LNS-W32 manual Mount the LIGHT-BLOCK Sheet and LIGHT-BLOCK Sheet Base

Page 10

5MOUNT THE LIGHT-BLOCK SHEET AND LIGHT-BLOCK SHEET BASE

1. Mount the light-block sheet on the lens. (In the same position as the removed sheet has been placed). Use the sheet included with the lens.

Make sure the mark (TOP and BACK) on Light-Block Sheet and set them properly.

2.Mount the light-block sheet base included with the lens.

LIGHT-BLOCK

SHEET

Type PC1

LIGHT-BLOCK

(Part No. 610 310 7967)

SHEET BASE

FRONT

CABINET

6MOUNT THE FRONT CABINET AND LENS COVER

1. Mount the front cabinet with 2 screws.

Lens cover is not used.

FOCUS ADJUSTMENT

Set up the projector and project image on the screen.

1.Loosen the Focus Lock Screw on the lens.

2.Rotate the lens to obtain proper focus on center area of the screen.

3.Tighten the Focus Lock Screw.

When proper focus is not observed at outer area of the screen, proceed to following adjustments.

4.Loosen the Focus Lock Ring of the lens. (Turn the Lock Ring to counter-clockwise.)

5.Rotate the lens to obtain proper focus on outer area of the screen.

6.Lock the Focus Lock Ring securely. (Turn the Lock Ring to clockwise.)

If proper focus is not observed entire screen, repeat above adjustment 1~ 6.

Focus Lock Ring

Focus Lock Screw

- 10 -

Page 9 Page 10
Image 10
Page 9 Page 10
Contents LIGHT-BLOCK Sheet Base Parts ListLens LIGHT-BLOCK SheetFig-2 Lens Replacement Procedure for a TypeFig-1 Fig-3Fig-5 Fig-7 Focus AdjustmentFig-6 Confirm the FocusFig-1-2 Lens Replacement Procedure for B TypeFig-1-1 Fig-1-3Lens Lock Latches Mount the Front Cabinet and Lens Cover See Remove the LIGHT-BLOCK Sheet Base and LIGHT-BLOCK Sheet Lens Replacement Procedure for C TypeRemove the Lens Cover and Front Cabinet Remove the LensMount the Lens Lens Lens Lock Lever Attachment Spacer DriverMount the LIGHT-BLOCK Sheet and LIGHT-BLOCK Sheet Base Mount the Front Cabinet and Lens Cover
Top Page Image Contents