Sanyo LNS-W32 manual Fig-5

Page 3

3REMOVE THE LENS (See Figure-5 and 6)

1. Disconnect the Lens Shift connector "K16L" from the circuit board on cabinet left side.

2.Disconnect the Zoom and Focus connector "K16J" from the circuit board.

Remove the lens motor lead from lead holder.

3.Remove screws-C (4 screws) which fastens the lens and remove the lens. Use the driver (3 mm, Green) included with the lens to remove the screws.

Be careful not to drop the lens when removing the screws.

LENSLEAD

MOTORHOLDER

CIRCUIT BOARD ON

CABINET LEFT SIDE

SCREW "C"

CONNECTOR "K16L"

LENS MOTOR LEAD

CONNECTOR "K16J"

Fig-5

-3-

Image 3

Contents LIGHT-BLOCK Sheet Parts ListLens LIGHT-BLOCK Sheet BaseFig-3 Lens Replacement Procedure for a TypeFig-1 Fig-2Fig-5 Confirm the Focus Focus AdjustmentFig-6 Fig-7Fig-1-3 Lens Replacement Procedure for B TypeFig-1-1 Fig-1-2Lens Lock Latches Mount the Front Cabinet and Lens Cover See Remove the Lens Lens Replacement Procedure for C TypeRemove the Lens Cover and Front Cabinet Remove the LIGHT-BLOCK Sheet Base and LIGHT-BLOCK SheetLens Lens Lock Lever Attachment Spacer Driver Mount the LensMount the Front Cabinet and Lens Cover Mount the LIGHT-BLOCK Sheet and LIGHT-BLOCK Sheet Base