Lens Lock Latches

3REMOVE THE LENS (See Figure-3 and 4)

1. Remove the lens motor connector from terminal.

2.Loosen the screws-B (2 screws) which fastens the lens. {Use the driver (4 mm, Yellow) included with the lens to loosen the screws.}

3.Slide the lens lock latches to "UNLOCK" position and remove the lens.

Be careful not to drop the lens when removing the screws. After using, save the driver for latter use.

SCREW "B"

LENS LOCK

LATCHES

CONNECTOR

Fig-3

TERMINAL

LOCK

POSITION

UNLOCK

POSITION

4MOUNT THE LENS (See Figure-5)

1. Remove protective caps (front and back) on the lens.

2.Mount the lens on lens mounting bracket with Upper 2 screws.

Use the driver (4 mm, Yellow) included with the lens to fasten the screws.

Remove the lower 2 screws on the Lens. (Lower 2 screws are not used.)

3. Slide the lens lock latches to "LOCK" position and lock the lens. (See Figure-4)

Project picture on screen and confirm the focus. If proper focus is not observed at screen, adjust focus following Focus Adjustment on next page.

LENS MOUNTING

BRACKET

DRIVER

IN THE LENS

LOWER SCREWS

-6-