Focus Adjustment, Fig-6, Fig-7, Confirm the Focus

4MOUNT THE LENS (See Figure-5 and 6)

1. Remove protective caps (front and back) on the

lens.

2.Mount the lens on lens mounting bracket with 4 screws.

Use the driver (4 mm, Yellow) included with the lens to fasten the screws.

CONFIRM THE FOCUS

Project picture on screen and confirm the focus. If proper focus is not observed at screen, adjust focus following Focus Adjustment on this page.

5MOUNT THE LIGHT-BLOCK SHEET AND FRONT PANEL (See Figure-7)

1. Mount the light-block sheet to the lens as shown in the Figure-7. Use the sheet included with the lens.

2.Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly.

3.Mount the Front Panel (Separately ordered) with the screws.

Light block sheet base is not used.

DRIVER

IN THE LENS

LENS MOUNTING

BRACKET

LIGHT-BLOCK SHEET

Type PD1

(Part No. 610 294 3047)

FRONT PANEL (OPTIONAL PART)

Set up the projector and project image on the screen.

1.Loosen the Focus Lock Screw on the lens.

2.Rotate the lens to obtain proper focus on center area of the screen.

3.Tighten the Focus Lock Screw.

When proper focus is not observed at outer area of the screen, proceed to following adjustments.

4.Loosen the Focus Lock Ring of the lens. (Turn the Lock Ring to counter-clockwise.)

5.Rotate the lens to obtain proper focus on outer area of the screen.

6.Lock the Focus Lock Ring securely. (Turn the Lock Ring to clockwise.)

If proper focus is not observed entire screen, repeat above adjustment 1~ 6.

Focus Lock Ring

Focus Lock Screw

-4-