Zebra Technologies TTP 2100 manual Installation, Installing a Paper Guide

3

Installation

Installing a Paper Guide

The TTP 2100 printers are delivered without paper guide fitted.

1.Open the printhead by pushing the green printhead open lever backwards and lifting up the printhead. See Clearing Paper Jams on page 34.

2.Insert the T-shaped tabs of the paper guide into the “T”-holes, and press the rear of the guide down and in.

3.Fasten the nut using the 5 mm wrench supplied.

4.Close the printhead.

Figure 4 • Fitting the Paper Guide

P rim a ry in p u t g u ide

T -ta bs

N u t

S c re w

When a guide is fitted, make an auto calibration with the ticket media that you are going to use in the printer. Most ticket medias auto calibrate perfectly, and the printer is ready to use. Should auto calibration fail on your media, set up paper width parameter n48, and sensor selected parameter n63 to reflect your media. Then redo the auto calibration.

5.Start the utility program Zebra Toolbox. This application is available from http://www.zebra.com.

6.Select Tools Parameter Settings.

11/04/2009 TTP 2100 Operator Guide P1021708-001