Zebra Technologies TTP 2100 manual + 2 4

Installation

Connecting the Power

In kiosk applications you may draw power from a common PSU in the kiosk if the characteristics are suitable. In such a case, cables that fit the connector on the back of the TTP 2100 are available from Zebra. If you make cables of your own, connect the voltages according to the following illustration.

Note • Protective ground and minus output should not be interconnected in the power supply.

At the printer end of the cable, use a Tyco Mate-N-Lok connector housing and two contact- sockets.

Figure 15 • Power Connection

27

G N D
+ 2 4 V
	Housing:		Socket:
Tyco No. 350777-1		Tyco No. 350689-1
	Table 2 • Current Consumption
Mode	58-60 mm paper width	80 – 82.5 mmpaper width
Idle	150 mA	150 mA
Standard text printing	0.7 A average	1	A average
All black printing	4 A	6	A

11/04/2009 TTP 2100 Operator Guide P1021708-001