| |||
Installation | |||
Mounting surface |
|
|
|
|
|
| Female BNC connector |
|
|
| (connect to video device) |
|
| Base |
|
|
|
| DC plug with terminal block |
|
| Mounting screw |
|
Zoom |
|
|
|
|
|
| DC Jack |
|
|
| (connect to power) |
|
|
| Important: Do not cut DC jack or BNC connector as |
|
|
| warranty will be voided. |
|
| Service Monitor Port | Service monitor adapter |
|
|
| |
|
| Focus | Connect to service monitor |
|
| at the installation site | |
|
|
| |
| Dome | Connects to Service | |
|
| Monitor Port | |
Before Starting
1.This product was designed for indoor use only. Do not mount the CCTV camera where it is exposed to rain or other moisture, or in humid or dusty places.
2.Do not point the CCTV camera at the sun. Heat could damage the camera, even when not in use.
3.Do not mount the CCTV camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals.*
4.Do not open or disassemble the camera. There are no user serviceable parts inside.
5.Do not drop the camera or subject it to strong vibrations.
Note: Many video monitors produce strong electromagnetic fields close to the display CRT, especially when the monitor is turned on or during de- Gaussing, which occurs automatically with many monitors when the monitor is turned on.
Installation
1.Remove the dome by twisting counterclockwise. Be careful not to scratch the dome. Do not touch any of the components inside the dome.
2.Temporarily connect the camera to the video monitor via the video cable. If a service monitor is available, use the included service monitor adapter.
3.Temporarily connect the camera to a 12VDC power source. (24VAC may be connected for
4.Hold the base of the dome camera with your hand against the ceiling, and try various locations and angles while watching the video monitor to find the location which offers the best protection. Mark that location
with a pencil.
5.Run a hidden, permanent video cable from the monitor to the mounting location.
6.Run a hidden cable from the power supply to the mounting location.
7.Connect the two cables to the dome camera. Do not cut any wires, as warranty will be voided. If needed, use the included DC plug with terminal block.
8.Mount the base to the ceiling at the selected location.
9.Use the
10.Make any necessary adjustments to the Zoom and Focus by pulling the respective levers out and turning them clockwise or counterclockwise.
11.Replace the dome, taking care not to touch the camera or scratch the dome.
12.Test the camera again under the exact lighting conditions under which it is expected to be used.
3 |