Hawking Technology HNC720G Troubleshooting, Status LED, Condition LED Color, Reset and Restore

Page 44

A. Troubleshooting

Status LED

After powering up, the network camera performs a self-diagnostic to detect any hardware defects. The following table lists the LED patterns in general. In case of any fatal errors, the LED will blink in a pattern other than those below.

Condition	LED Color

During self-diagnostic after power on	Blinking in interchanged green and red

Ethernet signal is lost	Red LED is blinking until Ethernet is detected

Before network is setup	Steady green until IP address is confirmed

After network is setup	Blinks green every second

Any hardware failure	Other patterns

Reset and Restore

Restoring the factory defaults will erase any previous settings. Reset or restore the system after power on.

On the left side of the camera (if facing it), there is a button hidden in the pinhole, as shown in the picture. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to its normal state. If the system problems remain after reset, restore the factory settings and install again.

RESET: Insert a fine pen tip, paper clip, or similar object end to click on the button.

RESTORE:

1.Insert a fine pen tip or paper clip and hold the button down.

2.Wait for the self-diagnostic to run twice.

3.Withdraw the pen tip, paper clip, or similar object as soon as the second self-diagnostic starts.

44

Image 44

Contents Page Hawking Limited Warranty Before Using This Product Package Contents Installation Initial Access to the CameraHow to Use This Camera Main Screen with Camera View Client SettingsAppendix Page Unpack and Inspect Ethernet Installation Wireless LAN InstallationDI+ Software Installation Page Page Add a Password for Security Authentication Installing the Plug-in Primary User’s Capabilities Main Screen with Camera ViewClient Settings ConfigurationDisable Digital Zoom Digital OutputTilt Speed Auto Pan or PanAuto Patrol or Patrol StopClient Settings URL http//Network Camera/protocol.html For Best Real-time Video Images Administrator’s CapabilitiesConfigure for Optimal Performance Opening Accounts for New Users Building a Multimedia Web Attraction Site Demo on multiple sites mid-scale serviceProduct demo for e-business Large-scale Service Page Building a Security Application Send snapshots when motion is detected Software Revision Upgrade Definitions in Configuration System Parameters User Group Administration Network settings Wlan ConfigurationGeneral StreamingPage Smtp Page Audio Parameters Video Codec ParametersPage Motion Detection Application Setup Weekly ScheduleEvent operation Sequential operationPage Camera control area Preset function areaCamera Control UPnP and Ddns Settings Page Viewing System Parameters Remote ControllerViewing System Log Factory default Troubleshooting Reset and RestoreStatus LED Condition LED ColorFrequently Asked Questions FAQ Page Capture update Snapshot of Jpeg image Restore factory default settingsQuery status of the digital input Drive the digital outputURL Homepage name Referenced URLSystem resource URL Resource name Referenced URLGeneral format of command URL System configuration URLSecurity configuration URL Network configuration URLWlan Ssid Page Ddns & UPnP configuration URL Mail&FTP Configuration URL Audio/Video configuration URL Camera control URL Image quality configuration URLNormal image Application configuration URL How to View Your Camera via the Internet Page Save/Cancel Page Page Page Technical Specifications System Camera SpecificationNetworking VideoLED indicator DimensionWeight Power