Vivotek IP7137 manual Sequential operation, Method for sending snapshot

Page 42

“Motion detection” and a note will show to direct the User to the configuration page for motion detection.

“Send pre-event image(s)” The number of pre-snapshots will be captured and send when a condition is triggered.

“Send post-event image(s)” The number of post-snapshots will be captured and send when a condition is triggered.

“Delay second(s) before detecting next motion” Set the time delay before restarting to check on the triggering condition when the current condition is triggered.

Sequential operation

“Snapshot interval (seconds)” Network Camera will send snapshots at the specified intervals to the external server using the method selected below. Remember: This operation is still subject to the conditions set in the weekly schedule.

Method for sending snapshot

“Email” This selects the uploading method following the intervals set above. The snapshot named “prefix-yyyymmdd-hhmmss.jpg” will be attached in the email. “FTP” The snapshots will be uploaded to the external FTP server with the file name defined in the next option. This can also be used to refresh the captured images stored in the external web server to build creative homepages.

“FTP put snapshots with date and time suffix” This option sets up the snapshot capture date and time, which can be used to easily differentiate the snapshot file names in the sequential operation. For instance, “prefix-20030102-030405.jpg” means the JPEG image was captured in the year 2003, January the 2nd, at 3 o’clock, 4 minute, and 5 second. If this suffix is omitted, the file named “video.jpg” on the external FTP server will be refreshed at the specified interval.

- 41 -

www.vivotek.com

Image 42
Contents Page Technical@vivotek.com Before You Use This Product Table of Contents FTP Configuration file Upgrade firmware Technical specifications Package Contents Installation Hardware installationSoftware installation To install in EthernetInitial Access to the Network Camera Check Network SettingsAdd Password to prevent Unauthorized Access How to Use AuthenticationInstalling plug-in Primary user’s capability Main Screen with Camera ViewDigital Zoom SnapshotClient settings Page Re-connect Administrator’s capability Fine-tuning for Best PerformanceFor Best Real-time Video Images Page Protect Network Camera by passwords Opening accounts for new usersBuild a security application Software revision upgrade Definitions in Configuration System parameters Security settings LAN & PPPoE Network settingsNetwork type Get IP address automatically & Use fixed IP addressHttp Rtsp StreamingUrl http//Network Camera/setup/network.html Wlan Configuration Tkip AES Page Ddns Access List General Video SettingsAudio and Video Video orientationAudio settings Image Settings Email & FTP FTPUrl http//Network Camera/setup/mailftp.html Motion detection Snapshot file name prefix Application settingsWeekly schedule Send out the snapshot while motion detectionSequential operation Method for sending snapshotPage Page System log Viewing system parameters Maintenance Troubleshooting Reset and restoreStatus LED URL commands of the Network Camera Get server parameter valuesMethod GET/POST Length is the actual length of content Set server parameter valuesWhere parameter pair is parameter=value\r\n Available parameters on the server WirelessNetwork CameraSkip to invoke default server Yyyy/mm/ddGroup Security Blank192.168.0.99 255.255.255.0554 5558 Group Wireless restartDefault 5556Group IPFilter 000000000000000000 0.0256 640x480 ForComputer 512000 For 60Hz only128000 AAC4 for computerGamr for mobile 12200To take effect Script.vssx Application page CGI command IP address514 Page Capture single snapshot MaxsizeAccount management System logs Privilege=confConfiguration file Upgrade firmwarePost data Technical specifications NetworkingTechnology License Notice MPEG-4 AAC Technology MPEG-4 Visual TechnologyElectromagnetic Compatibility EMC Liability