Vivotek IP7137 manual Troubleshooting, Status LED, Reset and restore

Page 48

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.

Condition

LED color

 

 

Loading system after power on

Steady blue

 

 

During booting procedure

Steady blue and red

 

 

Detecting and setting network

Steady blue and blink red till IP address is

 

confirmed

 

 

After network is setup (system up)

Blink blue every second and steady red

 

 

During the upgrade firmware process

Blink blue every second and fast blink red

 

 

Reset and restore

There is a button in the back of the Network Camera. It is used to reset the system or restore the factory default settings. Sometimes resetting the system sets the system back to normal state. If the system problems remain after reset, restore the factory settings and install again.

 

RESET:

Click on the button.

Restoring the factory defaults

RESTORE:

1. Press on the button continuously.

 

 

2. Wait for self-diagnostic to run twice.

will erase any previous settings. 3. Free the button as soon as the second Reset or restore the system after self-diagnostic starts.

power on.

- 47 -

www.vivotek.com

Image 48
Contents Page Technical@vivotek.com Before You Use This Product Table of Contents FTP Configuration file Upgrade firmware Technical specifications Package Contents Installation Hardware installationSoftware installation To install in EthernetInitial Access to the Network Camera Check Network SettingsAdd Password to prevent Unauthorized Access How to Use AuthenticationInstalling plug-in Primary user’s capability Main Screen with Camera ViewDigital Zoom SnapshotClient settings Page Re-connect Administrator’s capability Fine-tuning for Best PerformanceFor Best Real-time Video Images Page Protect Network Camera by passwords Opening accounts for new usersBuild a security application Software revision upgrade Definitions in Configuration System parameters Security settings Network settings Network typeLAN & PPPoE Get IP address automatically & Use fixed IP addressHttp Rtsp StreamingUrl http//Network Camera/setup/network.html Wlan Configuration Tkip AES Page Ddns Access List Video Settings Audio and VideoGeneral Video orientationAudio settings Image Settings Email & FTP FTPUrl http//Network Camera/setup/mailftp.html Motion detection Application settings Weekly scheduleSnapshot file name prefix Send out the snapshot while motion detectionSequential operation Method for sending snapshotPage Page System log Viewing system parameters Maintenance Troubleshooting Reset and restoreStatus LED URL commands of the Network Camera Get server parameter valuesMethod GET/POST Length is the actual length of content Set server parameter valuesWhere parameter pair is parameter=value\r\n WirelessNetwork Camera Skip to invoke default serverAvailable parameters on the server Yyyy/mm/ddGroup Security Blank192.168.0.99 255.255.255.0554 Group Wireless restart Default5558 55560000000000 00000000Group IPFilter 0.0256 640x480 ForComputer 512000 For 60Hz onlyAAC4 for computer Gamr for mobile128000 12200To take effect Script.vssx Application page CGI command IP address514 Page Capture single snapshot MaxsizeAccount management System logs Privilege=confConfiguration file Upgrade firmwarePost data Technical specifications NetworkingTechnology License Notice MPEG-4 AAC Technology MPEG-4 Visual TechnologyElectromagnetic Compatibility EMC Liability