Madrigal Imaging N38 manual Store Your Selection

Page 20

Results of unrealistic tests

You may elect not to use either Record Output with this particular device, as may be the case if you have several devices in your system that are capable of recording. In this case, leave the display on “RECD NONE” and move to Step 6.

You may also select either Record Output 1 or 2 to be associated with this particular input. To do so, press the input button repeatedly until you see your choice of OUT1 or OUT2 in the display. (OUT1 is given as an example on the next page.)

6STORE YOUR SELECTION

Save your choice in non-volatile memory by pressing and holding the Mode button until the display reads NEW DATA, as below.

Note: The Nº38 Preamplifier has been optimized to yield optimum sonic performance under normal, real-world operating conditions. This approach involves no disadvantage when the unit is used as designed.

Unrealistic tests such as listening at full gain to an unterminated input which has been associated with an unterminated record output may result in some small amount of noise at the main output which does not occur when the Nº38 is used correctly. Moreover, even under these unrealistic test conditions, any resulting noise is small and poses no danger.

Rather than compromise the sonic performance of the preamplifier in an effort to eliminate even the remote possibility of this noise being detected, the set-up procedure outlined above for programming input aliases was designed to make it virtually impossible to create a condition under which any such noise can be heard. We recommend using the input alias NOT USED for all unused inputs.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operating Manual Madrigal Audio Laboratories, IncPage Important Safety Instructions Page Table of Contents Page Unpacking and Placement Operating Voltage Turn OFF Your Associated Components Turn on Your Source Component Turn on Your Power AmplifierQuick Start… Mode Indicators Mode ButtonFront panel Display Intensity ButtonInverted Polarity Indicator Output LevelMono Button Source Selector ButtonsRear panel Balanced Main OutputsRecord Outputs SINGLE-ENDED Main OutputsBalanced Inputs 1 Slave and Master Communicator Ports External IR Input Remote Control Set-up and Installation Not Used DATVCR CASPress and Hold the Mode Button AGAIN… If Your Alias MAY Require AN INPUT…Store Your Selection Decide Which Source has the Highest Output Press and Hold the Mode Button on the Front PanelRaise the Volume to Match Your Reference Select the Input Whose Level YOU would Like to Automate P O R T a N T Press and Hold the Mute ButtonAdjust the Volume Knob to Your Preferred Setting Press and Hold the Mute Button AgainStandby Timer Time-outs in the Nº38 Operational Modes Page Using Surround Sound Processors Main Front Power Amplifier Ground Isolation Adaptor Linked Functions Care and maintenance Canadian Warranty Obtaining Service Specifications FAXDimensions Page Madrigal Audio Laboratories
Top Page Image Contents