Madrigal Imaging N38 manual Standby Timer Time-outs in the Nº38

Page 25

Standby Timer

Time-outs in the Nº38

I M P O R T A N T

In a similar fashion, the user of a Nº38 or Nº38S can elect to have the preamplifier (and the entire system, if Linked) go into standby after a certain period of time, much like a “Sleep Timer” on many alarm clocks. To engage the Standby Timer on the Nº38/S:

1.press and hold the standby button until the display reads TIME OFF.

2.turn the volume knob to select a time between 1 and 120 minutes. (Example: TIME 60 would turn off the system in an hour.)

3.the display will now time out and return to normal

4.the preamp (or Linked system) will go into standby at the appointed time one time only (so you don’t have to live with the product turning itself off every 60 minutes thereafter…).

Note: As a fail-safe against accidental changes (perhaps by smaller children, for example), changes made in various set-up modes are never made permanent without a second, confirming action on the users’ part, such as pressing and holding the Mode button a second time after a change is made. If a Set-up mode is entered accidentally, the Nº38 will time-out, or return to normal operation, after approximately ten seconds of inaction on the users’ part. No changes are made to the existing set-up when the Nº38 reverts to normal operation via a time-out.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Madrigal Audio Laboratories, Inc Operating ManualPage Important Safety Instructions Page Table of Contents Page Unpacking and Placement Operating Voltage Quick Start… Turn on Your Source Component Turn on Your Power AmplifierTurn OFF Your Associated Components Mode Button Mode IndicatorsFront panel Display Intensity ButtonOutput Level Inverted Polarity IndicatorMono Button Source Selector ButtonsBalanced Main Outputs Rear panelBalanced Inputs 1 SINGLE-ENDED Main OutputsRecord Outputs Slave and Master Communicator Ports External IR Input Remote Control Set-up and Installation DAT Not UsedVCR CASIf Your Alias MAY Require AN INPUT… Press and Hold the Mode Button AGAIN…Store Your Selection Raise the Volume to Match Your Reference Press and Hold the Mode Button on the Front PanelDecide Which Source has the Highest Output Select the Input Whose Level YOU would Like to Automate Press and Hold the Mute Button P O R T a N TPress and Hold the Mute Button Again Adjust the Volume Knob to Your Preferred SettingStandby Timer Time-outs in the Nº38 Operational Modes Page Using Surround Sound Processors Main Front Power Amplifier Ground Isolation Adaptor Linked Functions Care and maintenance Canadian Warranty Obtaining Service FAX SpecificationsDimensions Page Madrigal Audio Laboratories
Top Page Image Contents