Madrigal Imaging N38 manual Important Safety Instructions

Page 3

Important Safety Instructions

Please read all instructions and precautions carefully and completely before operating your Nº38 Preamplifier.

1.ALWAYS disconnect your entire system from the AC mains before connecting or disconnecting any cables, or when cleaning any component.

2.This product is equipped with a three-conductor AC mains power cord which includes an earth ground connection. To prevent shock hazard, all three connections must ALWAYS be used. If your electrical outlets will not accept this type of plug, an adapter may be purchased. If an adapter is necessary, be sure it is an approved type and is used properly, supplying an earth ground. If you are not sure of the integrity of your home electrical system, contact a licensed electrician for assistance.

3.AC extension cords are not recommended for use with this product. If an extension cord must be used, be sure it is an approved type and has sufficient current-carrying capacity to power this product.

4.NEVER use flammable or combustible chemicals for cleaning audio components.

5.NEVER operate this product with any covers removed.

6.NEVER wet the inside of this product with any liquid.

7.NEVER pour or spill liquids directly onto this unit.

8.NEVER block air flow through ventilation slots or heatsinks.

9.NEVER bypass any fuse.

10.NEVER replace any fuse with a value or type other than those specified.

11.NEVER attempt to repair this product. If a problem occurs, contact your Mark Levinson® retailer.

12.NEVER expose this product to extremely high or low temperatures.

13.NEVER operate this product in an explosive atmosphere.

14.ALWAYS keep electrical equipment out of the reach of children.

15.ALWAYS unplug sensitive electronic equipment during lightning storms.

Image 3
Contents Madrigal Audio Laboratories, Inc Operating ManualPage Important Safety Instructions Page Table of Contents Page Unpacking and Placement Operating Voltage Turn on Your Source Component Turn on Your Power Amplifier Quick Start…Turn OFF Your Associated Components Display Intensity Button Mode IndicatorsMode Button Front panelSource Selector Buttons Inverted Polarity IndicatorOutput Level Mono ButtonBalanced Main Outputs Rear panelSINGLE-ENDED Main Outputs Balanced Inputs 1Record Outputs Slave and Master Communicator Ports External IR Input Remote Control Set-up and Installation CAS Not UsedDAT VCRIf Your Alias MAY Require AN INPUT… Press and Hold the Mode Button AGAIN…Store Your Selection Press and Hold the Mode Button on the Front Panel Raise the Volume to Match Your ReferenceDecide Which Source has the Highest Output Select the Input Whose Level YOU would Like to Automate Press and Hold the Mute Button P O R T a N TPress and Hold the Mute Button Again Adjust the Volume Knob to Your Preferred SettingStandby Timer Time-outs in the Nº38 Operational Modes Page Using Surround Sound Processors Main Front Power Amplifier Ground Isolation Adaptor Linked Functions Care and maintenance Canadian Warranty Obtaining Service FAX SpecificationsDimensions Page Madrigal Audio Laboratories