Sony SR82, SR62, SR300, SR200, DCR-SR42 manual For the State of California, USA only

Page 5

Declaration of Conformity

Trade Name: SONY

Model No.: DCR-SR82

Responsible Party: Sony Electronics Inc.

Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A

Telephone number: 858-942-2230

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

Trade Name: SONY

Model No.: DCR-SR200

Responsible Party: Sony Electronics Inc.

Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A

Telephone number: 858-942-2230

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

Trade Name: SONY

Model No.: DCR-SR300

Responsible Party: Sony Electronics Inc.

Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A

Telephone number: 858-942-2230

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Notes

DCR-SR42,DCR-SR62,DCR-SR82,DCR-SR200 and DCR-SR300 are to be used with the Handycam Station Model DCRA-C171 and AC Adaptor Model AC-L200/L200B.

CAUTION

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

Note

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

For the State of California, USA only

Perchlorate Material - special handling may apply, See

www.dtsc.ca.gov/hazardouswaste/perchlorate

Perchlorate Material: Lithium battery contains perchlorate.

5

Image 5
Contents Operating Guide Use Service InstallationFor customers in the U.S.A. Read this firstFor customers in the U.S.A Owner’s RecordFor the State of California, USA only Battery pack About language setting When the camcorder is connected to a computerOn recording Save all your recorded image dataTable of Contents Getting Started Checking supplied itemsOn the Remote Commander except for DCR-SR42 Using the Remote Commander for the first timeTo change the battery of the Remote Commander To remove the battery pack Charging the battery packTo charge the battery pack using only the AC Adaptor Available running time for the supplied battery packTo reset the date and time Turning the power on, and setting the date and timeChanging the language setting Turn the Power switch to turn on your camcorder Adjust the LCD panelPreparing for recording Fasten the grip belt and hold your camcorder correctlyTurn the Power switch until the respective lamp lights up Slide the lens cover switch to open DCR-SR42/SR62/SR82Recording Recording/Playback Start recordingInserting/ejecting a Memory Stick Duo To record still images on a Memory Stick DuoTo change the recording media Still images On Easy Handycam operationRecording/Playback Start playback PlaybackTouch the tab, and the movie to be played back Touch the , or tab, and the still image to be played backTo adjust the sound volume of movies Nightshot Plus switch*1 Power zoom leverParts and functions used for the camcorder RecordingPlayback Connecting to other devicesConnect with the USB cable Ws Disc Burn button Wd USB jackIndicators displayed during recording/playback Upper left Indicators when you made changesUpper right CenterSaving images Saving images using a computerDeleting images Deleting the images on the hard diskPlaying the image on a Viewing Installing the supplied softwarePerforming with a computer If the screen does not appear Installing softwareFollow the on-screen instructions to install the software Using the Home MenuItems of the Home Menu Camera category Using the Option MenuView Images category Others categoryTab Settings categoryItems of the Option Menu Troubleshooting Cor E ssss Self-diagnosis display C04ss Self-diagnosis display/Warning indicatorsC13ss / C32ss E20ss / E31ss / E61ss E62ss / E91ss / E94ssHigh temperature warning Slow flashing Battery level warning Slow flashingLow temperature warning Fast flashing Fast flashingWhen not using your camcorder for a long time PrecautionsTo clean the LCD screen On use and careProcedures SpecificationsAbout care and storage of the lens SystemColor temperature General Input/Output connectorsNP-FH60 DCR-SR200/SR300 Rechargeable battery pack NP-FH40 DCR-SR42/SR62/SR82AC Adaptor AC-L200/L200B On trademarks