Jenn-Air W10349768A installation instructions Location Requirements, High Altitude Conversion

Page 4

Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See “Electrical Requirements” and “Gas Supply Requirements” sections.

It is recommended that all electrical connections be made by a licensed, qualified electrical installer.

High Altitude Conversion

To convert the cooktop for elevations above 6,560 ft (1999.5 m), order a High Altitude Conversion Kit.

Part Number W10237848 - LP high altitude

Part Number W10160841 - Natural gas high altitude

To order, see the “Assistance or Service” section of the Use and Care Guide.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air.

It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located under the console on the right-hand side.

It is recommended that a 600 CFM or larger range hood be installed above the range.

It is not recommended that a microwave hood combination be mounted above the range.

Recessed installations must provide complete enclosure of the sides and rear of the range.

To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets.

All openings in the wall or floor where range is to be installed must be sealed.

Do not seal the range to the side cabinets.

Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances.

The anti-tip bracket must be installed. To install the anti-tip bracket shipped with the range, see “Install Anti-Tip Bracket” section.

Grounded electrical supply is required. See “Electrical Requirements” section.

Proper gas supply connection must be available. See “Gas Supply Requirements” section.

Contact a qualified floor covering installer to check that the floor covering can withstand at least 200°F (93°C). Use an insulated pad or ¼" (0.64 cm) plywood over carpet and under range if installing range over carpeting.

IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C).

Mobile Home - Additional Installation Requirements

The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local codes.

In Canada, the installation of this range must conform with the current standards CAN/CSA-A240-latest edition, or with local codes.

Mobile home installations require:

When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above.

Product Dimensions

30" (76.2 cm) models

A

B

C

E

D

A. Optional backguard may be installed.

B. 27¾" (70.5 cm) depth with control panel, see NOTE*

C. 35¾" (89.6 cm) cooktop height when setting on the wheels D. 30" (76.2 cm) width

E. Model/serial rating plate location

4

Image 4
Contents Installation Instructions Commercial Style Dual Fuel Convection RangesRange Safety Your safety and the safety of others are very importantInstallation Requirements Tools and PartsMobile Home Additional Installation Requirements Product Dimensions 30 76.2 cm modelsMobile home installations require Location Requirements36 91.4 cm models Cabinet Dimensions 48 121.9 cm modelsIf connecting to a 4-wire system If connecting to a 3-wire systemElectrical Requirements U.S.A. Only Electrical ConnectionElectrical Requirements Canada Only Gas Supply RequirementsType of Gas Natural GasGas Supply Pressure Testing Unpack RangeGas Supply Line Gas Pressure RegulatorInstall Optional Backguard Install Anti-Tip BracketMeasurement B Measurement CElectrical Connection U.S.A. Only 30 76.2 cm and 36 91.4 cm ModelsWall Mounting 48 121.9 cm ModelsWire connection Power supply cord Ground-link screw Ground link bent away from rangeMake Gas Connection Verify Anti-Tip Bracket LocationLevel Range Complete ConnectionInstall Griddle Electronic Ignition SystemReinstall Kick Plate Complete Installation If you need Assistance or ServiceGAS Conversions LP Gas ConversionGas Supply Pressure Testing To Convert Gas Pressure RegulatorTo Convert Surface Burners Burner orifice spudComplete Installation Natural Gas ConversionSmall Burner A. Burner cap Strip Circuits Cooktop SchematicsBurner Cooktop SW4 SW5 SW6 Wiring Diagrams Atlas Board HMI Keyboard LCD48 121.9 cm Oven Schematic for Jdrp and Yjdrp Models Atlas Board HMI Keyboard LCDSécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteExigences D’INSTALLATION Outils et piècesDimensions du produit Modèles de 30 76,2 cm Exigences d’emplacementConversion pour utilisation en haute altitude Dimensions du placard Modèles de 36 91,4 cmSpécifications de lalimentation en gaz Spécifications de l’installation électriqueRemarque Dégagements minimums Type de gaz Canalisation de gazDétendeur Débit thermique des brûleurs AltitudeInstructions D’INSTALLATION Installation du dosseret facultatifInstallation de la bride antibasculement Déballage de la cuisinièreRaccordement au gaz Mesure CMontage au plancher Montage au murVérification de lemplacement de la bride Antibasculement Installation de la plaque à frireRéglage de laplomb de la cuisinière Système dallumage électroniqueRéglage de la taille des flammes Allumage initial et réglages des flammes de gazSi les brûleurs ne sallument pas correctement Hauteur de flammeRéinstallation du garde-pieds Achever linstallationSi vous avez besoin d’assistance ou de service Contrôle du fonctionnement du/des foursConversions Pour Changement DE GAZ Conversion pour lalimentation au propaneConversion du détendeur Test de pressurisation de la canalisation de gazConversion des brûleurs de surface Achever l’installationGicleur de brûleur Conversion pour lalimentation au gaz naturel Schémas des circuits Schémas de la table de cuisson Table de cuisson à 4 brûleursSMPS14VCC45W Schémas de câblageORVENTLATEUR~ DE Ventilaturde RefroidissmenteDuloquet Lampeshalogènes

W10349768A specifications

The Jenn-Air W10349768A is a premium range hood designed to enhance the functionality and aesthetic appeal of modern kitchens. With a blend of advanced technology and elegant design, this model meets the needs of culinary enthusiasts and homeowners alike.

One of the key features of the W10349768A is its powerful ventilation system. Equipped with a robust motor, it offers multiple fan speeds to efficiently eliminate smoke, odors, and airborne grease created during cooking. Its high airflow capacity ensures that even the most intense cooking sessions leave your kitchen fresh and clean. This range hood is particularly effective in larger kitchen spaces, making it a versatile choice for various layouts.

The design of the W10349768A prioritizes aesthetics as much as functionality. The sleek stainless steel finish not only provides a modern look but is also easy to clean and maintain, ensuring that it remains a focal point in your kitchen for years to come. The unit's minimalist design integrates seamlessly with a wide range of kitchen styles while providing the durability expected from a Jenn-Air product.

In terms of technology, the W10349768A features advanced noise reduction capabilities. It operates at a lower decibel level compared to traditional range hoods, making it ideal for open-concept living spaces where noise can disrupt conversations or the enjoyment of family gatherings. This attention to noise levels reflects Jenn-Air’s commitment to creating a pleasant cooking environment.

The range hood also comes with convenient features like adjustable lighting. Equipped with high-quality LED lights, it provides ample illumination for the cooking surface below, enhancing visibility while also being energy-efficient. This allows home cooks to monitor their meals effortlessly and adds an inviting ambiance to the kitchen.

Another notable characteristic of the W10349768A is its easy-to-use controls. The intuitive interface allows users to adjust fan speeds and lighting with just a touch, making it accessible for everyone in the household. Additionally, the dishwasher-safe filters ensure that maintenance is straightforward, promoting hygiene and performance.

All of these features make the Jenn-Air W10349768A a top choice for those looking to blend performance with style in their kitchen. Its powerful ventilation, modern aesthetics, and user-friendly technology position it as an essential tool for any serious home chef. Whether you're sautéing, grilling, or baking, this range hood is designed to enhance your culinary experience while elevating the overall design of your kitchen space.