SECTION 2
GENERAL
Location of controls
| SC | + | PTY | OPEN | |
DI | DSPL | ||||
| P | ||||
|
|
| R |
| |
|
|
| S |
| |
|
|
| T |
|
MENU |
| + | LIST |
|
|
|
|
| DSO |
|
|
|
|
|
|
| |||
| SOURCE |
|
|
|
|
|
| TA | |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| AF |
SOUND |
|
| ENTER |
|
|
|
|
|
|
P |
|
|
| REP | SHUF |
|
|
|
|
R |
|
|
|
|
|
|
| ||
S |
|
|
|
|
|
|
|
|
|
T | D I SC– |
|
|
|
|
|
|
|
|
- |
| MODE | 1 | 2 | 3 | 4 | 5 | 6 | |
OFF |
|
|
This section is extracted from instruction manual.
Setting the clock
The clock uses a
Example: To set the clock to 10:08
1 Press (MENU), then press either side of (PRST/DISC) repeatedly until “Clock” appears.
1Press (ENTER).
The hour indication flashes.
Refer to the pages listed for details.
1MENU button
9, 11, 12, 13, 15, 17, 18, 20, 21, 23, 24, 26, 27, 30, 31, 33, 34, 35
2Volume control dial
3SOURCE (TUNER/TAPE/CD/MD) button 6, 8, 10, 12, 13, 19, 20, 24, 25, 26, 27, 31, 34
4PRST/DISC +/– (cursor up/down) buttons 8, 9, 11, 12, 13, 15, 17, 18, 19, 20, 21, 22, 23, 24, 26, 27, 30, 31, 32, 33, 34, 35 During radio reception:
Preset stations select 13 During CD/MD playback:
Disc change 32
5DSPL/PTY (display mode change/ programme type) button
11, 18, 23, 31, 33
6LIST button
Disc memo 33
7Display window
8Z (eject) button (located on the front side of the unit behind the front panel) 10
9OPEN button 7, 10, 36 q; DSO button 26
qa SOUND button 24, 25, 26 qs OFF button* 6, 7, 8, 10
qd Reset button (located on the front side of the unit behind the front panel) 7
qf SEEK/AMS
Seek 13, 15, 19
Automatic Music Sensor 10, 32 Manual search 13, 32
qg ENTER button
9, 11, 12, 13, 15, 17, 18, 20, 21, 22, 23, 24, 26, 27, 30, 31, 33, 34, 35
qh MODE button 10, 11, 12, 13, 19, 20, 31, 34
During tape playback:
Playback direction change 10 During radio reception:
BAND select 12, 13 During CD/MD playback: CD/MD unit select 31
qj Receptor for the card remote commander
qk Number buttons During radio reception:
Preset number select 12, 13, 16, 17, 20, 21
During tape playback:
(1)REP 11
During CD/MD playback:
(1)REP 32
(2)SHUF 32
ql AF button 15, 17 w; TA button 16, 17
*Warning when installing in a car without ACC (accessory) position on the ignition key switch
Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine.
When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear.
2Press either side of (PRST/DISC) to set the hour.
3Press (+) side of (SEEK/AMS).
The minute indication flashes.
4Press either side of (PRST/DISC) to set the minute.
2 Press (ENTER).
The clock starts.
After the clock setting is complete, the display returns to normal playback mode.
Tips
•You can use the convenient CT function to set the clock automatically (page 18).
•When the D.Info mode is set to on, the time is always displayed (page 30).
5
Card remote commander RM-X91 (XR-C7500RX: E)
|
| OPEN/CLOSE |
OFF |
|
|
MENU | DISC | LIST |
SEEK |
| SEEK |
| SOURCE |
|
SOUND DISC 
ENTER
DSPLMODE
AT T | VOL |
| |
|
|
|
|
|
|
|
|
The corresponding buttons of the card remote commander control the same functions as those on this unit.
1OFF button
2MENU button
3SOURCE button
4SEEK/AMS (cursor </,) buttons
5SOUND button
6DSPL/PTY button
7ATT button
8LIST button
9DISC/PRST (cursor M/m) buttons
q; ENTER button qa MODE button qs VOL buttons
A unit turned off by pressing (OFF) for two seconds cannot be operated with the card remote commander unless (SOURCE) on the unit is pressed or a casette is inserted to activate the unit first.
3