JVC GR-DV900, GR-DV700 instruction manual Coloured bright spots appear LCD monitor

EN 69

33.	Coloured bright spots appear	33.	•The LCD monitor and the	33.
	all over the LCD monitor or the		viewfinder are made with
	viewfinder.		high-precision technology.
			However, black spots or
			bright spots of light (red,
			green or blue) may appear		—
			constantly on the LCD
			monitor or the viewfinder.
			These spots are not recorded
			on the tape. This is not due to
			any defect of the unit.
			(Effective dots: more than
			99.99 %)
34.	The indicators and the image	34.	•This may occur when the	34.
	colour on the LCD monitor are		surface or the edge of the		—
	not clear.		LCD monitor is pressed.
35.	The cassette will not load	35.	•The battery’s charge is low.	35. •Install a fully charged battery.
	properly.				( pg. 10, 11)
36.	The memory card cannot be	36.	—	36.	•Push in the memory card a
	removed from the camcorder.				few more times. ( pg. 16)
37.	Picture does not appear on the	37.	•The viewfinder is pulled out	37.	•Push the viewfinder back in
	LCD monitor.		and “PRIORITY” is set to		or set “PRIORITY” to “LCD”.
			“FINDER”.		( pg. 12, 31, 37)
			•The LCD monitor’s brightness		•Adjust the brightness of the
			setting is too dark.		LCD monitor. ( pg. 13)
					•If the monitor is tilted
					upward 180 degrees, open
					the monitor fully. ( pg. 12)
38.	Images on the LCD monitor	38.	•The speaker volume is too	38.	•Turn the speaker volume
	are jittery.		great.		down. ( pg. 20)
39.	The LCD monitor, the	39.		39.	•Wipe them gently with soft
	viewfinder and the lens have				cloth. Wiping strongly can
	become dirty (ex. fingerprints).		—		cause damage. ( pg. 73) To
					clean the viewfinder, please
					consult your nearest JVC
					dealer.	REFERENCES
40.	Time code does not appear.	40.	•“TIME CODE” is set to	40.	•Set “TIME CODE” to “ON”.
			“OFF”.		( pg. 31, 37, 40)
41.	An error indication (E01, E02	41.	•A malfunction of some kind	41.	•  pg. 81.
	or E06) appears.		has occurred. In this case the
			camcorder’s functions
			become unusable.
42.	An error indication (E03 or	42.	•A malfunction of some kind	42.	•  pg. 81.
	E04) appears.		has occurred. In this case the
			camcorder’s functions
			become unusable.
43.	The remote control does not	43.	•“REMOTE” is set to “OFF”.	43.	•Set “REMOTE” to “ON”.
	work.		•The remote control does not		( pg. 31, 36)
			point at the remote sensor.		•Point at the remote sensor.
			•The remote control batteries		( pg. 54)
			are exhausted.		•Replace the batteries with
					fresh ones. ( pg. 54)