JVC GR-X5EK, GR-X5EE manual How to Attach the Lens Cap, Attaching the Lens Hood

MasterPage: Start_Right GR-X5PAL.book Page 11 Thursday, April 7, 2005 7:23 PM

		GETTING STARTED EN 11
a AC Adapter AP-V17E or AP-V14E	Align.	Rotate clockwise.
b Power Cord (only for AP-V14E)
c Battery Pack BN-VF707U
d S-Video/Audio/Video Cable
e USB Cable
f Audio Extension Cable (for optional

	microphone, see page 12 for connection)	Rotate counterclockwise to remove it.
g	Audio Extension Cable (for optional
		● Remove the lens hood when attaching a
	headphone, see page 12 for connection)
		conversion lens or lens filter. If this type of lens is
h	Core Filter [large] (for USB cable, see page
		attached over the lens hood, the corners of the
	12 for attachment)
		image may be darkened (vignetting).
	Core Filter [large] (for power cord, only for
		How to Attach the Lens Cap
	AP-V14E, see page 12 for attachment)
i Core Filter [small] x5 (for S-Video/Audio/		To protect the lens, attach the provided lens cap
	Video cable, audio extension cable and AC
		to the camcorder as shown in the illustration.
	adapter’s cord, see page 12 for attachment)
j CD-ROM
k Remote Control Unit RM-V720U
l Lithium Battery CR2025* (for remote control
	unit)
m Memory Card 32 MB (already inserted in the
	camcorder)	NOTE:
n	Shoulder Strap (see the right column for
		To confirm the lens cap is
	attachment)
		on correctly make sure the
o	Lens Cap and its string (see the right column
		cap is flush to the
	for attachment)
		camcorder.
p	Battery Mount Cover** (already attached on
		Place here during
	the camcorder)
		shooting.

qCable Adapter

r Lens Hood (see below for attachment)	How to Attach the Shoulder Strap
* A lithium battery is pre-installed in the remote	Follow the illustration.
control unit at time of shipment (with insulation
	1 Thread the strap through the eyelet.
sheet). To use the remote control unit, remove the
insulation sheet.	2 Fold it back and thread it through the strap
** Attach the battery mount cover to protect the
	guide and the buckle.
battery connector when the battery pack is
	● To adjust the length of the strap, loosen and then
removed. For the attachment/detachment, refer to
“Charging the Battery Pack” ( pg. 13).	tighten the strap in the buckle.
	3 Slide the strap guide fully towards the eyelet.
NOTES:
	Strap guide
● In order to maintain optimum performance of the
camcorder, provided cables may be equipped with	Buckle
one or more core filter. If a cable has only one core	2
filter, the end that is closest to the filter should be
connected to the camcorder.
● Make sure to use the provided cables for
connections. Do not use any other cables.
Attaching the Lens Hood	1	3
When shooting outside or in bright locations,
light can sometimes reflect within the lens and
cause a whitish haze to appear over the subject	Eyelet
(flare). To prevent flare and provide extra
protection for the lens, attach the lens hood to
the camcorder.

GETTING STARTED