JVC GR-X5EK, GR-X5EE manual Insert Editing, To end insert editing, press START/STOP, then Stop

MasterPage: Start_Right GR-X5PAL.book Page 49 Thursday, April 7, 2005 7:23 PM

					EDITING	EN 49
● Never connect the USB cable and the DV			Insert Editing
cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
	You can record a new scene into a previously
camcorder.
● When using a DV cable, be sure to use the	recorded tape, replacing a section of the original
optional JVC VC-VDV206U or VC-VDV204U DV	recording with minimal picture distortion at the in
cable depending on the type of DV connector	and outpoints. The original audio remains
(4 or 6 pins) on the PC.	unchanged.
● If the PC connected to the camcorder via the USB	● Use the provided remote control.
cable is not powered, the camcorder does not	NOTES:
enter the USB mode.
	● Before performing the following steps, make sure
● The date/time information cannot be captured into
the PC.		that “TIME CODE” is set to “ON” in CAMERA
		DISPLAY and VIDEO DISPLAY menus.
● Refer to the instruction manuals of the PC and
		( pg. 33, 36, 38)
Software.
	● Insert editing is not possible on a tape recorded in
● The still images can also be transferred to a PC
		the LP mode or on a blank portion of a tape.
with a DV connector-equipped capture board.
	1 Play back the
● The system may not work properly depending on
the PC or capture board you are using.	tape, locate the edit-						START/
	out point and press						STOP
	PAUSE (9). Confirm			REW			PAUSE
	the time code at this
				INSERT			STOP
	point. ( pg. 19)

2 Press REW (3)

until the edit-in point is located, then press PAUSE (9).

3 Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the time code (min.:sec.) appear and the camcorder enters insert-pause mode.

4 Press START/STOP to begin editing.

● Confirm the insert at the time code you checked in step 1.

● To pause editing, press START/STOP. Press it again to resume editing.

5 To end insert editing, press START/STOP, then STOP (8).

NOTES:

● Program AE and special effects (
pg. 44, 45) can be used to spice up the scenes being edited during insert editing.

● During insert editing, the date and time information changes.

● If you perform insert editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

● During insert editing, when the tape moves to scenes recorded in the LP mode or a blank portion, insert editing stops. (
pg. 55)

ADVANCED FEATURES