MasterPage: Advan_Heading0_Right
20 EN
NOTES:
● The time code cannot be reset. |
VIDEO PLAYBACK
Normal Playback
● During |
code indication does not move smoothly. |
● The time code is displayed only when “TIME |
CODE” is set to “ON”. ( pg. 36) |
Quick Review
Enables to check the end of the last recording.
1) Press QUICK REVIEW (3) during the |
2) Tape is rewound for about several seconds |
and played back automatically, then pauses in |
the |
4/9
3 5
MENU 8
VIDEO/MEMORY Power Switch
A
Lock Button
VOL. +, –
● Distortion may occur at start of playback. This is |
not a malfunction. |
Recording from the Middle of a Tape
1)Play back a tape or use blank search
( pg. 21) to find the spot at which you want to start recording, then engage the still playback (pause) mode. (See the right column.)
2)Set the power switch to “A” or “M” while pressing down the lock button located on the switch, then start recording.
1
2 Set the VIDEO/MEMORY switch to “VIDEO”.
3 Set the power switch to “PLAY” while pressing down the lock button located on the switch.
4 To start playback, press 4/9.
5 To stop playback, press 8.
●During stop mode, press 3 to rewind, or 5 to
To control the speaker volume
Slide the power zoom lever (VOL. +,
NOTES:
●The playback picture can be viewed in the LCD monitor or on a connected TV. ( pg. 22)
●If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To turn on again, set the power switch to “OFF”, then to “PLAY”.
●When a cable is connected to the S/AV connector, the sound is not heard from the speaker.
Still Playback (Pause)
Pauses during video playback.
1)Press 4/9 during playback.
2)To resume normal playback, press 4/9 again.
● If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.