JVC TK-C215V4 Setting the Lens and Switches TK-C215V12, Alarm Position status indication lamp

Introduction

Setting the Lens and Switches (TK-C215V12)

Set the video setting switches on the camera unit before mounting it.

To set the switches, use a fine-tipped screwdriver.

		H			R	B			E
A	IRIS		LEVEL	WHT.BAL.			PHASELL	RESET/[SPOT]
B	ZOOM/FOCUS FAR TELE	L	[MEMORY]		4	4			F
						7
						8
C		NEAR				6			G
						3
D	POSITION SELECT WIDE		ALARM POSITION			5
					2	2
						1

Function selection switch setting table (Items in bold are factory position)

		OFF	ON
1	AGC	OFF	ON
2	SELECT	PHASE	WHT.BAL.
3	SYNC	LL	INT
4	WHT.BAL.	ATW	MANUAL
5	BLC	OFF	ON
6	DAY/NIGHT	OFF	ON
7	ALARM	TRIGGER	STATE
8	RESET/SPOT	RESET	SPOT

A [IRIS LEVEL] Iris level adjustment

For adjusting the level of the automatic aperture control lens. This adjustment only needs to be made when required. Use this to accommodate particular shooting conditions. To darken image: Counterclockwise (L side) To brighten image: Clockwise (H side)

NOTE:

Prior to adjusting the aperture level, ensure to set the 1 [AGC] Switch of the function selection switch G to AOFFB. Otherwise, when the level is turned too far toward L, the AGC function activates increasing sensitivity and the picture may look uneven.

B [ZOOM/FOCUS, MEMORY] zoom, focus adjustment switches/position memory button

Use the [JTELE] and [KWIDE] switches to zoom, and the [HFAR] and [INEAR] switches to adjust focus. (A pg. 25)

Press the [MEMORY] button to register the position. (A pg. 25)

C [ALARM POSITION] status indication lamp

Light off	: Registration of home
	position is enabled
Light on (red)	: Lens initializing.

Light on (green): Registration of alarm position is enabled

Blinking (green): Position memory registration mode N memory registration completed

(A pg. 25)

D [POSITION SELECT] POSITION SELECT button

Press this button to switch between the home and alarm positions. Display on the status indication lamp C will change accordingly. (A pg. 25)

E [RESET/SPOT] RESET/SPOT button When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value.

●When the 2 [SELECT] switch is set to [WHT.BAL.], the white balance is reset to the default value.

When the switch is set to PHASE, the phase is reset to the default value.

●When setting to SPOT:

When this button is pressed, white-spots are corrected.

For instructions on correcting white-spots, see AWhite-spot correctionB (A pg. 28).

F[R/B, +/-] R/B, +/- adjustment button This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock.

The function of this button is selected using the 2 [SELECT] switch.

●When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint.

Press the B button to increase the blue tint and decrease the red tint.

●When adjusting the phase:

Press the + or - button to adjust the phase.

GFunction selection switches

1.[AGC] Auto-gain control switch. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON)

12