JVC TK-C215V4, TK-C215V12 Mounting the Inner Dome, Mounting the Dome Cover, Mount the inner dome

Page 27

Other installation and adjustment

Mounting the Inner Dome

After setting is complete, mount the Inner dome.

Claws (3 locations)

Inner Dome

*TK-C215V4 is used in the above illustration.

1.Mount the inner dome .

Mount the inner dome to the claws (3 locations).

CAUTION:

●Mount the inner dome such that it does not cover the lens.

●When mounting the inner dome, be careful not to move the lens position. The image angle set previously will go out of alignment.

Mounting the Dome Cover

After setting is complete, mount the dome cover.

Position mark

1.

1.Mount the dome cover.

Align the position marks on the camera unit and dome cover, followed by pressing in directly to mount the cover.

CAUTION:

Press the dome over until a “click” sound is heard. Check that the cover is firmly mounted. Failure to mount the cover firmly may cause this cover to fall off.

27

Image 27

Contents For Customer Use TK-C215V4 TK-C215V12Business users Other Countries outside the European Union Safety PrecautionsInformation for USA Information Important Safeguards Contents Characteristics Note on consumable parts TK-C215V12 only Operating PrecautionsCamera Name of PartsCamera Interior Sync Synchronization system selection switch Setting the Lens Switches TK-C215V4RESET/SPOT RESET/SPOT button B, +/- R/B, +/- adjustment buttonRESET/SPOT RESET/SPOT Correction selection switch WHT.BAL. ATW/MANUAL selection switchBLC Backlight compensation switch DAY/NIGHT Easy Day & Night switchSetting the Lens and Switches TK-C215V12 Alarm Position status indication lampPosition Select Position Select button Trigger Alarm alarm input mode selection switchVideo signal cables DC 12 V or AC 24 V power supply cableAbout Connection Cables ‹ Polarity of alarm signals Electrical Specifications of Alarm Input TerminalsVideo Monitor System diagramMounting the Camera Getting StartedSelecting a mounting method Embedding the camera to the ceiling Setup Connecting Adjusting Images Mounting Open a hole in the ceiling. R 30 mm, 1 1/8 inches Fasten the camera by tightening the camera fastening screw Turn the camera unit in the clockwise directionWhen mounting the camera to the electrical box Adjusting ImagesMount by allowing the cable to exit from the side Adjusting Images Adjusting the camera directionMounting the test monitor Adjusting brightness Adjusting the field angle/focus/ brightness TK-C215V4Adjusting field angle Adjusting focus‹ Registering home position BAdjust the focusAdjust the brightness TK-C215V12 TK-C215V12 ‹ Registering alarm position Mount the dome cover Mounting the Inner DomeMounting the Dome Cover Mount the inner domeWhite-spot correction ‹ TK-C215V4‹ TK-C215V12 General Specifications Camera Lens External Dimensions Unit mm inches ‹ When cover is attached‹ When embedded Focus chart TK-C215V4/TK-C215V12 Dome Camera