JVC TK-C215V4, TK-C215V12 manual Turn the camera unit in the clockwise direction

T	UP
N
	ROF

1.	Outer case
	mounting screws
	Less than 4 mm
Attach from	2.
the ceiling
slab	3.
Fall prevention
wire
(not supplied)
	Be sure to loosen
	the screw.

TK-C215V4 is used in the above illustration.

4.Connect the video signal cable. (A pg. 14)

Lower the protection cover and connect the connectors. Upon connecting, restore the protection cover to cover the connectors.

5.Connect the input power supply cable. (A pg. 16)

6.Connect the alarm cable.(TK-C215V12 only) (A pg. 15)

7.Wrap insulation tape around cables.

Alarm signal cable (TK-C215V12 only)

Mounting

1.Align the position mark of the fastened outer case with that of the camera unit.

NOTE:

When doing so, be careful not to catch the cables in the outer case.

2.Turn the camera unit in the clockwise direction.

T When doing so, ensure that the X mark is visible. (See illustration below)

3.Fasten the camera by tightening the camera fastening screw.

Position mark

1. 2.T Check

Camera fastening screw

3.

*TK-C215V4 is used in the above illustration.

4.

Protection cover

5.6.

Solder or crimp

Insulation tape

Wrap with tape

7.

Input power supply cable

Adjusting Images

After mounting is completed, adjust the

images while checking the actual image. (A pg. 23 AAdjusting ImagesB)

*TK-C215V12 is used in the above illustration

21