Setting the Lens Switches TK-C215V4, LL Line Lock

Introduction

Setting the Lens and

Switches (TK-C215V4)

Set the video setting switches on the camera unit before mounting it.

To set the switches, use a fine-tipped screwdriver.

ARESET/[SPOT]

LLPHASE

1 O

2 N 2

C	4	4
	3
	5		WHT.
	5
	6
	7		BAL.
	8

L H

IRIS

ELEVEL

FOCUS ADJUST

Function selection switch setting table (Items in bold are factory position)

		OFF	ON

1	AGC	OFF	ON
2	SELECT	PHASE	WHT.BAL.
3	SYNC	LL	INT
4	WHT.BAL.	ATW	MANU
5	BLC	OFF	ON
6	DAY/NIGHT	OFF	ON
7	RESERVED	SET TO OFF
8	RESET/SPOT	RESET	SPOT

A [RESET/SPOT] RESET/SPOT button

When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value.

●When the 2 [SELECT] switch is set to WHT.BAL., the white balance is reset to the default value.

When the switch is set to PHASE, the phase is reset to the default value.

●When setting to SPOT:

When this button is pressed, white spots are corrected.

For instructions on correcting white spots, see AWhite-spot correctionB (A pg. 28).

B[R/B, +/-] R/B, +/- adjustment button

This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock.

The function of this button is selected using the 2 [SELECT] switch.

●When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint.

Press the B button to increase the blue tint and decrease the red tint.

●When adjusting the phase:

Press the + or - button to adjust the phase.

CFunction selection switches

1.[AGC] Auto-gain control switch. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON)

2.[SELECT] WHT.BAL./PHASE setting switch.

WHT.BAL.:

The B [R/B, +/-] buttons are used as [R/B] adjustment buttons.

PHASE:

The B [R/B, +/-] buttons are used as [+/-] adjustment buttons.

(Default setting: WHT.BAL.)

3.[SYNC] Synchronization system selection switch.

This switch sets the synchronizing system for the camera.

INT:

This is set for internal synchronization

LL (Line Lock):

The camera’s vertical synchronization is locked to the AC 24 V 60 Hz power line frequency. When switching between multiple cameras using a switcher, selecting this mode and adjusting the vertical phase can reduce the monitor sync disturbances occur that when the camera image is switched.

(Default setting: INT)