JVC TK-T2101RU, TK-T2101RE manual Backlight, Pict Adjust, Atr, Motion DET, Privacy

Page 14

OSD SETTINGS

PUSH: When selected in the appropriate position, the whole area will perform white balance.

PUSH LOCK: When selected in the appropriate position, WHITE BALANCE will perform once.

3.4 BACKLIGHT

Set Backlight compensation function. It controls the light level to overcome sever backlight conditions. Available options include OFF, BLC or HLC (Highlight Compensation) mode. The default is OFF.

If HLC is selected, HLC is activated automatically when the camera detects high- luminance.

3.5 PICT ADJUST

PICTURE ADJUST allows you to adjust picture settings for optimal image. In the PICT ADJUST submenu, you can adjust BRIGHTNESS, CONTRAST, SHARPNESS, HUE and GAIN value. In addition, you can set MIRROR to ON to reflect the image.

MIRROROFF

BRIGHTNESS 000

CONTRAST 128

SHARPNESS 128

HUE128

GAIN128

3.6 ATR*

Set ATR (Adaptive Tone-curve Reproduction) function. You can select ON or OFF. The default is OFF. If selecting ON, you will enter the ATR submenu, where you can set LUMINACE and CONTRAST to optimize by image.

LUMINANCE LOW

CONTRAST LOW

*Also known as Wide Dynamic Range. This function expands the video dynamic range of the camera and improves visibility of images even in high contrast environments.

3.7 MOTION DET

MOTION DET allows to detect moving objects on the screen. The default is OFF. If selecting ON, you will enter the MOTION DET submenu. You can set up to 4 motion areas to detect moving objectives and adjust the motion detection sensitivity from 0 to 127.

3.8 PRIVACY

PRIVACY function mask up to 8 privacy areas on the screen from video monitoring. The default setting is OFF. If selecting ON, you will enter the PRIVACY submenu. You can configure up to 8 privacy areas and set color and transparency of the privacy zones. In addition, you can enable MOSAIC function for the privacy zone.

12

Image 14
Contents Instructions Page Important Safety Information Table of Contents Before You Begin DimensionsIntroduction Routine Maintenance Names of Camera PartsInstallation Disassembling the CameraConnecting the wiring Mounting the CameraOptional Camera Settings Camera adjustment controlsAdjusting the Camera Position Adjusting the LensCompleting the Installation Completing the installationSHUTTER/AGC OSD SettingsLens Lens Auto SHUTTER/AGC Auto High Luminance Mode Auto Iris White BALATR Pict AdjustBacklight Motion DETCamera ID Camera ResetDAY/NIGHT LanguageSpecifications Ntsc PAL