JVC GR-AX940 manual Tape Dubbing

Repeat steps 4 through 6 for additional editing, then stop the VCR and camcorder when finished.

Basic Connections

1 CONFIRM POWER-OFF STATUS Make sure the camcorder’s power is off.

2 CONNECTVCR CAMCORDER TO TV OR

Pull out the connector cover and open it. Connect as shown in the illustration (☞ pg. 42).

If using a VCR . . . go to step 3.

If not . . . go to step 4.

3 CONNECTINPUT VCR OUTPUT TO TV

Refer to your VCR’s instruction manual.

4 SUPPLY POWER

Turn on the camcorder, the VCR and the TV.

5 SELECT MODE

Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

NOTES:

●It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the battery pack (☞ pg. 9).

●To monitor the picture and sound from the camcorder without inserting a tape, set the camcorder’s Power Switch to “CAMERA” (“AUTO” or “PRO.”), then set your TV to the appropriate input mode.

●Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

●If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

EN43

Tape Dubbing

CONNECT EQUIPMENT
1 Following the illustration on pg. 42, connect the
camcorder and the VCR.
PREPARE FOR DUBBING
2 Set the camcorder’s Power Switch to “PLAY”,
turn on the VCR’s power, and insert the
appropriate cassettes in the camcorder and the
VCR.
SELECT VCR MODE
3 Engage the VCR’s AUX and Record-Pause
modes.
FIND EDIT-IN POINT
4 Engage the camcorder’s Play mode to find a spot
just before the edit-in point. Once it is reached,
press PLAY/PAUSE (4/6) on the camcorder.
START EDITING
5 Press PLAY/PAUSE (4/6) on the camcorder and	PLAYBACK
engage the VCR’s Record mode.
STOP EDITING TEMPORARILY
6 Engage the VCR’s Record-Pause mode and press
PLAY/PAUSE (4/6) on the camcorder.
7 EDIT MORE SEGMENTS