JVC LYT0329-001B manual Access Manual Focus, Adjust Focus, END Adjustment of Focus

Power lamp

		F
	F
Y	O		5S
A
L
P

Lock Button

EN37

MANUAL FOCUS

NOTE:

You should already have made the necessary viewfinder adjustments (☞ pg. 11). If you have not, do so before continuing.

SELECT OPERATION MODE

1 Set the Power Switch to “ ” or “ ” while pressing

down the Lock Button located on the switch, and pull

out the viewfinder fully or open the LCD monitor

fully.

ACCESS MANUAL MODE ITEM MENU

2 Press the Select Dial. The Manual Mode Item Menu

appears.

ACCESS MANUAL FOCUS

3 Move the highlight bar to “FOCUS” by rotating the

Select Dial, then press it. Rotate the Select Dial to

Select Dial

Display

4FOCUS		MANUAL
EXPOSURE		AUTO
W. BALANCE		AUTO
FADER		OFF
	/ WIPE
P. AE		OFF
	/ EFFECT
FLASH ADJ.		0
END
FOCUS

FOCUS

Power Switch

Manual Mode Item Menu

	display “MANUAL”, then press it. The Manual Mode	RECORDING
	Item Menu disappears and “FOCUS” is displayed in
	the upper left corner. The focus is locked at this point.
	ADJUST FOCUS
4 To farther subject . . .
	.... rotate the Select Dial upward. “ ” appears and
	blinks. Go to step 5.
	To nearer subject . . .
	.... rotate the Select Dial downward. “ ” appears
	and blinks. Go to step 5.
	END ADJUSTMENT OF FOCUS
5 Press the Select Dial. Focus adjustment is complete.
	The indication changes from “FOCUS” to
	“MANUAL”.

•If you want to reset the focus, repeat from step 2.

To Change To Auto Focus . . .

.... rotate the Select Dial to display “AUTO” then press it

in step 3. The manual focus indicators disappear. Or set the Power Switch to “ ”.

NOTES:

●After the Power Switch is set to “OFF”, Manual Focus is reset to “AUTO”.

●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a certain subject in the wide-angle position, sharply focused images cannot be obtained when zoomed up because the depth-of-field is reduced at longer focal lengths.

●When the focus level cannot be adjusted any farther or closer, “ ” or “ ” will blink.