JVC LYT0329-001B Digital Dubbing, Make Connections, Start Playback, RM-V711U Provided Play Stop

To DV OUT

DV cable (provided with GR-DVL9600, optional for GR-DVL9500)

Lock Button

PLA

Y

O

F

F

5S

Power Switch

EN53

Digital Dubbing

It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

1 CONFIRM POWER-OFF STATUS Make sure the camcorder’s power is off.

2 MAKE CONNECTIONS

Connect the camcorder to your video unit equipped with a DV connector using the DV cable as shown in the illustration.

3 START PLAYBACK

Press PLAY (4) to play back the source tape.

4 START RECORDING

While watching the playback on the monitor, engage the DV connector-equipped video unit’s record mode from the spot on the source tape you want to begin recording.

To DV IN

Video unit equipped with DV connector

RM-V711U

T W (provided)

PLAY (4)

STOP (5)

NOTES:

●It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack (☞ pg. 7).

●For Digital Dubbing, the GR-DVL9600 or GR-DVL9500 can be connected only to one device at a time. The GR-DVL9600 can also be used as a recorder. When using the GR-DVL9500 for dubbing, be sure to use it as a player. The GR-DVL9500’s DV connector is only for output.

●If a blank portion is played back during dubbing, an unusual image may be dubbed.

●Even though the DV cable is connected correctly, some- times the image may not appear in step 3. If the above occurs, turn off power and make connections again.

●If “Playback Zoom” (☞ pg. 56), “Playback Special Effects” (☞ pg. 57) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV OUT connector.

●During Digital Dubbing, the scenes recorded in High Speed Recording mode are divided into 2, and the image is

displayed both in the upper and lower halves of the screen (☞ pg. 45).

●Be sure to use a DV cable with the core filter.

●Be sure to wind the DV cable twice around the core filter attached to the end connected to the camcorder.

To Use This Camcorder As A Recorder (GR-DVL9600 only) . . .

1.Turn the Power Switch to “ ” while pressing down the Lock Button located on it.

2.Connect the DV cable as shown in the illustration and load a cassette to record on.

3.Press the Recording Start/Stop Button to engage the Record-Pause mode. “DV IN” appears on the screen.

4.Press the Recording Start/Stop Button to start recording. “DV IN” changes to “ DV IN ”.

5.Press the Recording Start/Stop Button again to engage the Record-Pause mode. “ DV IN ” returns to “DV IN”.

NOTES:

●During Digital Dubbing, the image is dubbed using the recording mode selected in the Recording Menu (☞ pg. 10).

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting (☞ pg. 30).