12
GETTING S
TARTED (cont.)
Loading/Unloading A Cassette
|
| 4 | 3 |
| 1 | 5 | 2 |
1 |
|
| Turn to take |
| up slack. |
Erase Protection | Gear |
OPEN LCD MONITOR
1 Press PUSH/OPEN and open the LCD monitor to an angle of over 60 degrees.
OPEN CASSETTE HOLDER
2 Press EJECT until the holder opens. Do not use force to open.
INSERT/REMOVE CASSETTE
3 Make sure the label is facing outward.
CLOSE CASSETTE HOLDER
4 Press PUSH and make sure the holder is closed and locked.
CLOSE LCD MONITOR
5 First make sure the holder is closed. Then close the LCD monitor.
NOTES:
●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor.
●A cassette holder can’t be opened unless a power supply is attached.
●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.
●Make sure the Erase Protection tab is present. If not, cover the hole with adhesive tape. (Some cassettes have sliding tabs – in this case, check the tab's position.)