JVC GR-AXM1U Prepare Camcorder, Prepare VCR, Access R.A. Edit Counter Display, Make Corrections

REW/FF CANCEL

IN/OUT

R.A. EDIT

PLAY/PAUSE

STOP

37

PREPARE CAMCORDER

2 Insert a recorded tape and set the power switch to PLAY.

PREPARE VCR

3 Turn the power on, insert a recordable tape and engage the AUX mode (refer to VCR’s instructions).

SELECT SCENES

ACCESS R.A. EDIT COUNTER

DISPLAY

1 Press PLAY/PAUSE, then press R.A. EDIT and the counter display appears in the LCD monitor or the viewfinder and the screen of the connected TV.

To EDIT

Editing cable (optional 3.5 ø mini-plug cable)

C	A
	B

To Remote

PAUSE

To Pause-In

To AUDIO and VIDEO out connector

Audio and Video cable (optional)

To AUDIO and

VIDEO IN connectors

REGISTER BEGINNING OF SCENE

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under IN on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under OUT on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

VCR (Recording deck)

RM-V700U (optional)

IN	OUT
ç♣ 1 0:00:25
2
3
4			IN	OUT
5
6		ç 1	0:00:25	0:01:05
7		2	0:03:18	0:03:31
8		3	0:02:33	0:02:53
COUNTER	0:00:25	♣ 4	0:04:11
TOTAL	0:00:00	5
		6
		7
		8
		COUNTER		0:04:11
		TOTAL		0:01:13

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●The camcorder prerolls during R.A. Edit, so there must be at least 15 seconds of recording material prior to any in-point.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing R.A.EDIT clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.