FIND EDIT-IN POINT
4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
5 Press and hold INSERT, and press PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.
BEGIN INSERT EDITING
6 Press Recording Start/Stop. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the playback mode.
NOTES:
RESET COUNTER
Locate the point and press PAUSE on the camcorder or the remote control.
FIND EDIT-OUT POINT
Set the power switch to PLAY.
1
2
3 Press and hold COUNTER R/M for more than 2 seconds to reset the tape counter, then press for less than 1 second and make sure “M” appears in the LCD monitor or the viewfinder.
39
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
You need the RM-V20U remote control unit to perform this procedure.
SELECT MODE
COUNTER R/M
POWER
M-0:12:34Tape Counter
Insert editing indicator
LCD monitor or viewfinder
REW
PLAY
PAUSE
AUDIO DUB
INSERT
RM-V20U (optional)
●When Insert Editing is performed with the LCD monitor fully opened, the original audio will be heard from the speaker.
●Insert Editing may not work correctly if a blank segment exists in the recorded tape, or if the recording speed was changed.
●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.
●To edit onto a tape with the recording safety tab removed, cover the hole with adhesive tape.
●Only video signal is recorded in the Insert Editing mode. When the sound is to be recorded, press
AUDIO DUB and PAUSE simultaneously after step 5. When INSERT and PAUSE are pressed simultaneously again, the unit re-enters the Video-signal-only Recording mode.
●If the camcorder’s mike is too close to the TV, or if the TV’s volume is too high, whistling or howling may occur.
